Page 36 / 63
Scroll up to view Page 31 - 35
Manual Ver1.0
- 36 -
Select your Dynamic DNS service provider from ‘D-DNS provider’, and enter your
registration information. Click “Save/Apply” to save the configuration.
Figure 41. Advanced Setup – DNS – Add Dynamic DNS
Page 37 / 63
Manual Ver1.0
- 37 -
5.7 - DSL
This page allows you to choose which handshake protocols you want your M404/M405 to
look through when training. Uncheck any of the listed protocols that have “Enabled” at the
end of it to have the modem skip that protocol when synchronizing with your ADSL line.
Leave it checked if you would like the modem to cycle through those settings.
Figure 42. Advanced Setup – DSL Settings
.
Page 38 / 63
Manual Ver1.0
- 38 -
5.8 - Internet Time
The M404/M405 can synchronize its internal time with an Internet time server when
available. To enable this function, check “Automatically synchronize with Internet time
servers”. Select First and Second NTP time server from the pull down menu. Or select
“Other” and define your preferred NTP server. Choose the time zone from “Time zone
offset”. Click on “Save/Apply” to save the configuration.
Figure 43. Advanced Setup - Internet Time
5.9 - Access Control Services
Services
The M404/M405 browser management tool is protected by three categories: Services, IP
addresses, and Passwords. All three must be matched (if configured) to gain access to the
management tool.
All services are enabled from LAN side and disabled from WAN side by default.
Page 39 / 63
Manual Ver1.0
- 39 -
Figure 44. Advanced Setup - Access Control - Service
IP Addresses
The IP Address Access Control mode, if enabled, permits access to local management
services from IP addresses contained in the Access Control List. If the Access Control
mode is disabled, the system will not validate IP addresses for incoming packets. The
services are the system applications listed in the Service Control List.
Click “Add” to add an IP address to the Access Control List. To remove, mark the Remove
option of the specified IP address, then click “Remove” to remove the IP address from the
Access Control List. Up to 16 hosts can be configured here.
Page 40 / 63
Manual Ver1.0
- 40 -
Figure 45. Advanced Setup - Access Control – IP Addresses
Passwords
Access to your router is controlled through three user accounts:
admin
,
support
, and
user
.
admin
: has unrestricted access to change and view the M404/M405 configuration.
support
: is used to allow an ISP technician to access the M404/M405 for maintenance and to
run diagnostics.
user
: can access the M404/M405 to view configuration settings and statistics, as well as,
update the M404/M405 software.
Use the fields below to enter up to 16 characters and click “Save/Apply” to change or
create passwords.
19216811.live