Page 6 / 9 Scroll up to view Page 1 - 5
English
4
Your configuration is now complete.
For detailed information regarding the TWG-BRF114's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
CD-ROM, or TRENDnet's website at http://www.trendnet.com.
5.
Configure the settings based on
information provided by your ISP.
Follow the wizard instructions to
complete the configuration.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at:
www.trendnet.com/registe
r
Thank you for choosing TRENDnet
Page 7 / 9
5
Troubleshooting
Q1:
A1:
I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error message says
“The page cannot be displayed.” How can I get into the TWG-BRF114's web configuration page?
First, check your hardware settings again by following the instructions in Section 2.
Second, make sure the LINK/ACT light for the LAN port is lit.
Third, make sure your TCP/IP
settings are set to
Obtain an IP address automatically
(see the steps below).
1.
Go into the
Control Panel
and double-click the
Network Connections
icon, right-click the
Local Area Connection
icon and then click
Properties
.
2.
Click
Internet Protocol (TCP/IP)
and then click
Properties
.
Then click on
Obtain an IP
address automatically.
Fourth, press on the factory reset button for 15 seconds.
I am not sure what type of Internet Account Type I have for my Cable/DSL connection.
How do I find out?
Contact your Internet Service Provider's (ISP) support service for the correct information.
I went through the Setup Wizard, but I can not get onto the Internet.
What should I do?
First, verify that you can get onto the Internet with a direct connection into your modem.
Second, contact your ISP and verify all the information that you have in regards to your
Internet connection settings is correct.
Third, power cycle your modem and router.
Unplug
the power to the modem and router.
Wait 30 seconds, and then reconnect the power to the
modem.
Wait for the modem to fully boot up, and then reconnect the power to the router.
When I connect a computer to the router's LAN port, I am not getting Gigabit speeds.
What should I do?
Check the LED on the Switch.
Make sure the LED for 1000 is lit on for the LAN port.
If
it is not on, the computer is running at 10 or 100mbps speed.
Make sure that you have a
Gigabit Ethernet adapter installed.
Also make sure to use a Cat-5e or Cat 6 Ethernet cable.
Some CAT-5 cables are not rated to run in Gigabit.
If you still encounter problems or have any questions regarding the TWG-BRF114, please
contact TRENDnet’s Technical Support Department.
Q2:
A2:
Q3:
A3:
Q4:
A4:
Page 8 / 9
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento.
El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado.
El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
Page 9 / 9
Copyright ©2007. All Rights Reserved. TRENDnet.
20675 Manhattan Place
Torrance, CA 90501
USA
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
TRENDnet Technical Support
US
Canada
24/7 Tech Support
Toll Free Telephone:
1(866) 845-3673
Europe
(Germany
France
Italy
Spain
Switzerland
UK)
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone:
+(31) (0) 20 504 05 35
Toll Free Telephone:
+00800 60 76 76 67
.
.
.
.
.
.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top