Page 21 / 127
Scroll up to view Page 16 - 20
20
3.
Click
Browse
to
c
hoose the desired destination location. By
default, the destination location is C:\Program Files\Setup
Wizard.
Then click
Next >
.
4.
The InstallShield Wizard starts to install the software.
A
status
screen
appears
indicating
the
progress
of
the
installation.
5.
When the
InstallShield Wizard Complete
window appears,
click
Finish
.
.
Page 22 / 127
21
After installing the utility, the application program for the camera
is automatically installed to your computer, and creates a folder in
Start\Programs\SetupWizard.
Using Setup Wizard
This section describes the operation of Setup Wizard.
To launch
the Wizard:
1.
Click
Start
->
Programs
->
Setup Wizard
, and then click
SetupWizard
.
2.
The window below will appear.
The IP Camera Setup
Wizard will automatically search for IP Cameras within the
network.
Page 23 / 127
22
Wizard
-
Select IP Camera, then click
Wizard
-
If the Camera’s default IP is different than your
network’s IP subnet, the Wizard will help you to search
for a proper IP address. Click
YES
to change the IP
address.
-
Use the DHCP assigned IP address or manually set the IP
address. The IP address must match your network’s IP
subnet. Then click
OK
.
Page 24 / 127
23
Note:
Please note the IP address.
This is the IP address for
accessing the browser configuration of your camera from
your local area network. Your IP Address might look
different than the example above.
-
Assign Admin ID & Password here. By default, there is
no Admin ID and Password.
You can select “
Change
” to
type new Admin ID & Password.
Then click
Next
(Right
Arrow)
Page 25 / 127
24
-
Setup the Primary DNS or Secondary DNS if necessary.
Then click
Next
(Right Arrow)
-
Wireless Configure setting. (For TV-IP100W only)
Select the connection mode, type in your wireless
network’s SSID, select the security mode and then click
Next
(Right Arrow)
-
Select the Encryption Mode, key format and enter the
key.
Then click
Next
(Right Arrow).
19216811.live