Page 11 / 127
Scroll up to view Page 6 - 10
10
2. Link LED
A steady
ORANGE
light indicates that the camera has good
connection to LAN/WLAN. It begins flashing to indicate the
camera is receiving/sending data from/to the LAN/WLAN.
Rear Panel
1. Detachable Antenna
(TV-IP100W)
The detachable external antenna allows you to adjust its position
to obtain the maximum signal.
2. Power Connector
The DC power input connector is located on the back of Camera’s
rear panel, and is labeled DC5V with a single jack socket to
supply power to the Camera.
Power will be generated when the
power supply is connected to a wall outlet.
3. Reset Button
Reset will be initiated when this button is pressed. Factory Reset
will be initiated when this button is pressed continuously for five
seconds.
Page 12 / 127
11
4.10/100 Ethernet LAN Port
This RJ-45 connector is used to connect the 10Base-T Ethernet or
100Base-TX Fast Ethernet network (which should be Category 5
twisted-pair cable). The port supports the N-Way protocol &
Auto-MDIX, it allowing the camera automatically detects or
negotiates the transmission speed of the network.
Page 13 / 127
12
2
H
ARDWARE
I
NSTALLATION
Attaching the Camera to the Stand
The Camera comes with a camera
stand, which has a swivel ball
screw head that can be attached to
the top/bottom of camera’s screw
hole. Attach the camera to the
stand and station it for your
application.
There are three holes
located in the base of the stand
allowing
the
Camera
to
be
mounted on the ceiling or any
wall securely.
Page 14 / 127
13
Connecting the Ethernet cable
Connect an Ethernet cable to the
RJ-45 Port, and then connect it to
the network.
Attaching the Power Supply
Attach the power supply to the
power connector of the Camera.
Then connect the power supply to
the wall outlet.
Page 15 / 127
14
3
S
ECURITY
To ensure the highest security and prevent unauthorized usage of
the camera, the administrator has the exclusive privilege to access
the System Administration for settings and control requirements
to allow users the level of entry and authorize the privileges for
all users.
The camera supports multi-level password protection.
Access to the camera is strictly restricted to define the user who
has a “User Name” and “User Password” that is assigned by the
administrator.
The administrator can release a public user name and password to
allow remote users to access the camera.
NOTE:
Since the default settings are Null String, it is highly recommended to
set the "Admin Password" when you are the first time to use the camera.
Once the password is defined, only the administrator is permitted to manage
the camera. The security feature of the camera will not be enabled until the
"Admin Password" is defined; therefore, you have to complete this procedure
as soon as possible.
19216811.live