11
Troubleshooting
Q1:
A1:!
Q2:
A2:!
Q3.
A3:
Q4.
A4:
address!bar,!but!an!error!message!says!"The!page!cannot!be!displayed".!How!can!
I!get!into!the!TEW-453APB's!web!configuration!page?
Please make sure that your workstation and the TEW-453APB are in the same
network segment.
Make sure you change your workstation's IP Address to
192.168.0.X where “X” is a number from 1 to 227 and 229 to 254.
If your
workstation and the TEW-453APB lie in the same network segment, then double-
check the connection between the TEW-453APB and your switch, and make sure
that the power adapters for your switch and the TEW-453APB are plugged in.
After!I!successfully!configured!the!Access!Point!to!meet!my!network!settings,!
I!cannot!connect!to!my!network!using!wireless!computers.
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select #Obtain an IP automatically# for Windows 98/ME and
#Obtain an IP Address automatically# for Windows 2000/XP to allow the PC to
regain an IP address from your DHCP server.
When!I!configure!the!network!settings!for!the!TEW-453APB,!I!don't!have!a!
Domain!Name!Server,!but!the!TEW-453APB!requires!a!DNS!entry.!!What!do!I!do?
In this case, your DNS entry is the same as your Gateway's entry.
So if
your Gateway is 192.168.1.1, then your DNS is 192.168.1.1.
All!the!settings!are!set!correctly,!but!I!still!can't!use!the!Access!Point,!what!
should!I!do?
You can find additional information in the User's Guide. If you still have
problems, contact our Technical Support by email or phone.
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2)
This device must accept any interference received including interference that may cause
undesired operation.
19216811.live