Given below is full router user manual of TRENDnet TEW-434APB router model. You can also download this manual in PDF Format to read later on your computer.
Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.
Page 2 / 13
Table of Contents
Version 01.08.2007
English
......................................................................................................
Troubleshooting
........................................................................................
1
1
2
3
5
8
1. Before You Start
2. Hardware Installation
.........................................................................
4. Configure the Access Point
................................................................
.................................................................................
3. Power-over-Ethernet Installation
......................................................
Page 3 / 13
Installation Requirements
Application
Web Browser: Internet Explorer (5.5 or higher)
A computer with a network adapter properly installed
A network Switch or Hub with an available network LAN port
A RJ-45 network cable
Power over Ethernet Switch (Optional)
TPE-101I (Optional)
Package Contents
1. Before You Start
English
1
TEW-434APB
Quick Installation Guide
User’s Guide CD-ROM
AC Power Adapter (7.5V 1A)
1 x 2dBi Detachable Antenna
Note: The TEW-434APB only support Power over Ethernet (PoE) devices that
follow the IEEE 802.3af Mode A (pin 1, 2, 3, 6) standard
Cable/DSL 4-Port Firewa l Router
(TW100-BRF114
)
Workstation with
PCI Adapter
(TE100-PCIWN)
Cable/DSL
Modem
Internet
Workstation with
Wireless PCI Adapter
(TEW-423PI)
Notebook with
Wireless PC Card
(TEW-421PC)
54Mbps 802.11g Wireless
PoE Access Point
(TEW-434ABP)
Power over Ethernet
(PoE) Injector
(TPE-101i
)
PoE + Data
Data
100Mbps
Page 4 / 13
3.
Verify that the following front panel
lights are on:
WLAN
and
LAN
.
2. Hardware Installation
English
2
2.
Connect the Power Adapter to the
Access Point and then to a power
outlet.
Note: Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network. Please connect
the computer configuring the TEW-434APB to the same switch/hub.
1.
Connect a RJ-45 cable from the
Switch/Hub to the
LAN
port of the
Access Point and then connect the
2dBi Detachable Antenna.
Page 5 / 13
3. Power-over-Ethernet Installation
English
3
Using the TEW-434APB with a PoE switch
2.
Verify that the following panel lights
are on:
WLAN and LAN
.
Please
refer to step 3 in the Hardware
Installation section.
1.
Connect a RJ-45 cable from the
Power-over-Ethernet Switch (e.g.
TRENDnet TPE-S88) to the
LAN
port of the Access Point and then
connect the 2dBi Detachable
Antenna.
19216811.live