Page 46 / 63
Scroll up to view Page 41 - 45
TD-8840
ADSL2+ Modem Router User Guide
40
Figure 4-30
To remove an existing entry, follow the steps below.
1.
Check the box in the
Remove
column of the entry as shown in Figure 4-29.
2.
Click the
Remove
button below.
4.3.5 Routing
Choose “
Advanced Setup
→
Routing
” menu, you can see two submenus under the Routing
menu as shown in Figure 4-31.
Figure 4-31
4.3.5.1. Default Gateway
Choose “
Routing
→
Default Gateway
” menu, you can configure the Default Gateway routing in
the next screen as shown in Figure 4-32.
Page 47 / 63
TD-8840
ADSL2+ Modem Router User Guide
41
Figure 4-32
¾
Enable Automatic Assigned Default Gateway -
Select this checkbox, and then the Router
will accept the first received default gateway assignment from one of the PPPoA, PPPoE or
MER/DHCP enabled PVC(s). If this checkbox is not selected, you have to enter the static
default gateway and/or an interface. Click
Save/Apply
to save your configurations.
)
Note:
If changing the
Enable Automatic Assigned Default Gateway
from unselected to selected, you
must reboot the Router to get the automatic assigned default gateway.
4.3.5.2. Static Route
Choose “
Routing
→
Static Route
” menu, you can view and add the Static Route entry in the next
screen as shown in Figure 4-33. A static route is a pre-determined path that network information
must travel to reach a specific host or network.
Figure 4-33
Page 48 / 63
TD-8840
ADSL2+ Modem Router User Guide
42
To add a new entry, follow the steps below.
1.
Click the
Add
button in Figure 4-33 to go to the
Static Route Add
page as shown in Figure
4-34.
2.
Enter the IP address of the destination network. This parameter specifies the IP network
address of the final destination.
3.
Enter the Subnet Mask for the destination.
4.
Select the
Use Gateway IP Address
checkbox and enter the IP address of the gateway. The
gateway is an immediate neighbor of your ADSL Router that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same segment as your Router;
over Internet (WAN), the gateway must be the IP address of one of the remote nodes.
5.
Click
Save/Apply
to save your configurations. Then you will go back to Figure 4-33 and see
your new entry.
Figure 4-34
4.3.6 DSL
Choose “
Advanced Setup
→
DSL
” menu, you can view and configure the parameters in the
screen as shown in Figure 4-35. If you want to make some advanced settings, click
Advanced
Settings
button to go to the
DSL Advanced Settings
page as shown in Figure 4-36.
Page 49 / 63
TD-8840
ADSL2+ Modem Router User Guide
43
Figure 4-35
Figure 4-36
If you want to select the tone, click the
Tone Selection
button to go to the ADSL Tone Settings
page as shown in Figure 4-37.
Page 50 / 63
TD-8840
ADSL2+ Modem Router User Guide
44
Figure 4-37
4.4
Diagnostics
Choose “
Diagnostics
”, and your modem will test your DSL connection. Then you will see the test
results for the connectivity to your local network and your DSL service provider similar to Figure
4-38.
Figure 4-38
19216811.live