Wireless-N Broadband Router

Chapter 1: Introduction

Thank you for choosing the W302R Wireless-N Broadband Router. It employs the advanced MIMO

(Multi Input, Multi Output) technology and integrates router, wireless access point, four-port switch and

firewall in one, which will allow you to share Internet access over the four switched ports or via the

wireless broadcast. Compatible with IEEE 802.11n (Draft 2.0) standard, it can connect

with existing

802.11b/g PCI, USB and Notebook adapters. Up to 300Mbps transmission rate allows you to enjoy

real-time activities such as video streaming, online gaming and so on.

Besides, the Wireless-N Broadband Router supports all of the latest wireless security features, such as

64/128-bit WEP encryption, WPS (PBC and PIN) encryption method, packet filtering an

d port

forwarding

, to prevent unauthorized access and

protect your network against malicious attack.

Moreover, the user-friendly Setup Wizard on the CD-ROM can assist you to set up the Wireless-N

Broadband Router easily. It also can be managed or configured through Local/Remote easy-to-use

Web-based utility. So it is the best choice for SOHOs and small-sized enterprises.

Package Contents

±

One W302R Wireless-N Broadband Router

±

One Ethernet Network Cable

±

One Quick Installation Guide

±

One Power Adapter

±

One CD-ROM

If any of listed items are missing or damaged, please contact the Tenda reseller from whom you

purchased for replacement immediately.

1

Wireless-N Broadband Router

Chapter 2: Getting to Know the Wireless-N Broadband Router

The Rear Panel

Here is the description of the back panel. The RJ-45 ports for cable connection and Reset button are

located on the back panel as shown below.

Connections:

Rear Panel Interface

Description

LAN Ports(1-4)

Connect to Ethernet devices (such as computers, switches,

hubs).

RESET

Note:

After pressing the RESET button for 7 seconds, the

configurations you have set will be deleted and the device will

restore to the factory default settings.

WAN

Connect to DSL Modem, Cable Modem or community

broadband

DC IN

Receptor for the supplied power adapter.

2

Wireless-N Broadband Router

The Front Panel

There are the Router’s LED indicators on the front panel as shown below.

LEDS:

LED Indicator

Status

Description

POWER

Always ON

The POWER indicator is Always ON when it is powered on and

works properly.

SYS

Blinking

The SYS is blinking regularly when the system works normally.

Always ON

Indicates the correct connection of the WAN ports.

WAN

Blinking

Indicates the Router is transmitting/receiving data packets.

WLAN

Blinking

Indicates the wireless signal is OK.

Always ON

Indicates the correct connection of the LAN ports.

LAN(1/2/3/4)

Blinking

Indicates the Router is transmitting/receiving data packets.

WPS

Blinking

Indicates the Router is negotiating with WPS clients in WPS Mode

(PBC

or PIN Code

).

3

Wireless-N Broadband Router

Hardware Installation

1. Please connect the LAN port of the router to

the network adapter of your computer with one

cable.

2.Please use the delivery-attached power

adapter to power the router.

3.Please connect your broadband line provided

by your ISP to the WAN port of your router.

IMPORTANT: Please use the included power adapter. Use of a different power adapter could

cause damage and void the warranty for this product.

4

Wireless-N Broadband Router

Chapter 3: Getting to Connect the Wireless-N Broadband Router

For easy and fast configuration, the following steps for network configuration are required.

How to Set the Network Configurations for My Computer

Right click “

My Network Places

” and select

“

Properties

”.

Right click “

Local Area Network Connection

”

and select “

Properties

”.

5