Page 56 / 165
Scroll up to view Page 51 - 55
Telsey
telecommunications
Web Interface
MT500--SIEN12
48
Enter the destination network address, subnet mask, gateway address and/or
avaliable WAN interface. By clicking on Save/Apply, the entry is included in the
routing table.
RIP
By clicking on
RIP
, the following page will show up.
Page 57 / 165
Telsey telecommunications
Web Interface
49
MT500--SIEN12
To activate RIP for the device, select “Enabled” radio button for global RIP
mode. To configure an individual interface, select the desired RIP version (
1
,
2
or
both
) and operation (
Active
,
Passive
), followed by placing a check in the
“Enabled” checkbox for the interface. Click the “Save/Apply” button to save the
configuration, and to start or stop RIP based on the global RIP mode selected.
DSL
The DSL Settings dialog box allows you to select an appropriate modulation
mode.
By clicking on
DSL
in the Advanced Setup menu, the following page will show
up.
Tab. 11: DSL modulation settings
Option
Description
Auto Mode (G.Dmt, G.lite or
T1.413)
Sets the system auto-sense between G.Dmt, G.lite, or
T1.413.
G.Dmt/G.lite
Sets G.Dmt/G.lite if you want the system to use either
G.Dmt or G.lite mode.
T1.413
Sets the T1.413 if you want the system to use only
T1.413 mode.
G.Dmt
Sets the system to use only G.Dmt mode.
G.lite
Sets the system to use only G.lite mode.
Page 58 / 165
Telsey
telecommunications
Web Interface
MT500--SIEN12
50
By clicking on Advanced Settings, it is possible to select an appropriate test
mode.
The following page shows the DSL Advanced Settings page.
All three of these modes enable PSD measurements for each phase of training
and showtime.
Tab. 12: DSL Advanced Settings - Test mode choice
Option
Description
Normal
Normal mode of operation.
Reverb
Send Reverb signal only.
Medley
Send Medley signal only.
No retrain
Stay in showtime even after the modem is
disconnected.
Page 59 / 165
Telsey telecommunications
Web Interface
51
MT500--SIEN12
The
Tone Selection
button prompts the ADSL Tone Settings dialog box. This
allows you to select an appropriate number of upstream and downstream
tones.
Click Apply after you have made your selections.
Page 60 / 165
Telsey
telecommunications
Web Interface
MT500--SIEN12
52
VOICE
The
Voice
menu enables VoIP SIP settings.
SIP
By clicking on
SIP
(Voice sub-menu), the following configuration page shows
up.
19216811.live