1. Home
    2. /
  2. Manuals
    3. /
  3. Technicolor
    4. /
  4. TG788vn
    5. /
  5. 24
Page 116 / 159 Scroll up to view Page 111 - 115
5
Telephone cable
Connect the telecommunication line cord only in the PSTN, FXO, DSL, ADSL, SHDSL, VDSL or Line port of the
product. Never plug the telecommunication line cord in another receptacle of the product.
Follow the installation instructions in the sequence as outlined in the installation guide.
Central splitter / distributed filter(s) (if applicable)
If telephone service is required on the same line, a central splitter or distributed filter(s) must be installed for optimal
DSL performance.
Depending on your DSL configuration and type of splitter / filters, installation must be carried out by qualified service
personnel. Consult your telephone service company or DSL service provider for instructions.
Accessibility
The Direct Plug-in power supply, or the plug on the power supply cord serves as disconnect device. Be sure that the
power socket outlet you plug the power supply into is easily accessible and located as close to the equipment as
possible.
Overloading
Do not overload mains supply socket outlets and extension cords as this increases the risk of fire or electric shock.
Servicing
To reduce the risk of electric shock, do not disassemble this product. None of its internal parts are user-replaceable;
therefore, there is no reason to access the interior. Opening or removing covers may expose you to dangerous voltages.
Incorrect reassembly could cause electric shock if the appliance is subsequently used.
If service or repair work is required, take it to a qualified service dealer.
Damage requiring service
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following
conditions:
When the power supply or its plug are damaged.
When the attached cords are damaged or frayed.
If liquid has been spilled into the product.
If the product has been exposed to rain or water.
If the product does not operate normally.
If the product has been dropped or damaged in any way.
There are noticeable signs of overheating.
If the product exhibits a distinct change in performance.
!
CAUTION
To reduce the risk of fire, use only No 26 AWG wire size or larger telecommunication line cord.
Page 117 / 159
6
Immediately disconnect the product if you notice it giving off a smell of burning or smoke. Under no circumstances
must you open the equipment yourself; you run the risk of electrocution.
Regulatory Information
You must install and use this device in strict accordance with the manufacturer's instructions as described in the user
documentation that is included with your product.
Before you start installation or use of this product, carefully read the contents of this document for device specific
constraints or rules that may apply in the country where you want to use this product.
In some situations or environments, the use of wireless devices may be restricted by the proprietor of the building or
responsible representatives of the organization.
If you are uncertain of the policy that applies on the use of wireless equipment in a specific organization or environment
(e.g. airports), you are encouraged to ask for authorization to use this device prior to turning on the equipment.
Technicolor is not responsible for any radio or television interference caused by unauthorized modification of the device,
or the substitution or attachment of connecting cables and equipment other than specified by Technicolor. The
correction of interference caused by such unauthorized modification, substitution or attachment will be the
responsibility of the user.
Technicolor and its authorized resellers or distributors are not liable for any damage or violation of government
regulations that may arise from failing to comply with these guidelines.
Europe - European Union
European Community Declaration of Conformity
This equipment can be used in all countries that are member of the European Union and that are member of the
European Free Trade Association.
The Declaration of Conformity can be found on www.technicolor.com
.
In case this product is equipped with a wireless transceiver:
it is restricted to indoor use only.
it complies with the basic restrictions and limits as defined in the European Council Recommendation (1999/519/
EC) on the limitation of exposure of the general public to Electromagnetic fields.
This product complies with:
Commission Regulation (EC) No 1275/2008 implementing Directive 2005/32/EC: Ecodesign requirements for
standby and off mode electric power consumption of electrical and electronic household and office equipment.
Commission Regulation (EC) 278/2009: Ecodesign requirements for no-load condition electric power
consumption and average active efficiency of external power supplies.
!
Hereby, Technicolor, declares that this product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC of the European Parliament and of the Council.
Page 118 / 159
7
North-America - Canada
Notification of Canadian Radio Frequency Interference Statement
This Class B digital apparatus complies with Canadian ICES-003.
NOTICE
: This product meets the applicable Industry Canada technical specifications.
NOTICE
: The ringer Equivalence Number (REN) for this terminal equipment is 0.1. The REN is an indication of the
maximum number of devices allowed to be connected to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices does
not exceed five.
Canada - Industry Canada (IC)
In case this product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver, complying with
RSS 210 and/or RSS 213 of Industry Canada, operation is subject to the following two conditions:
1
This device may not cause harmful interference.
2
This device must accept any interference received, including interference that may cause undesired operation
of the device.
Restricted Frequency Band
In case this product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver, it only uses
channels 1 to 11 (2412 to 2462 MHz) on Canada territory.
North-America - United States of America
Federal Communications Commission (FCC) Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
!
IMPORTANT NOTE: Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20 cm (8 inches) between the radiator and
your body.
Page 119 / 159
8
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
Responsible Party: Technicolor, 101W. 103rd St., Indianapolis, IN 46290 USA, 888-898-4377.
This equipment complies with Part 68 of the FCC Rules.
The customer information required for Telephone Terminal Equipment ("TTE") approved for connection to the Public
Switched Telephone Network ("PSTN"), pursuant to 47 CFR §68.218(b)(1) can be found at www.technicolor.com
.
RF-Exposure Statement
When the product is equipped with a wireless interface, then it becomes a mobile or fixed mounted modular transmitter
and must have a separation distance of at least 20 cm (8 inches) between the antenna and the body of the user or
nearby persons. In practice, this means that the user or nearby persons must have a distance of at least 20 cm (8 inches)
from the modem and must not lean on the modem in case it is wall-mounted.
With a separation distance of 20 cm (8 inches) or more, the M(aximum) P(ermissible) E(xposure) limits are well above
the potential this module is capable to produce.
The transmitter shall not be collocated with other transmitters or antennas.
Restricted Frequency Band
In case this product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver, it may only use
channels 1 to 11 (2412 to 2462 MHz) on U.S.A. territory.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including interference that may cause undesired
operation.
Page 120 / 159
9
CONSIGNES DE SÉCURITÉ ET INFORMATIONS RÉGLEMENTAIRES
AVANT D’INSTALLER OU D’UTILISER LE PRODUIT, LISEZ ATTENTIVEMENT CES INSTRUCTIONS
Réseau sans fil
Si le produit est équipé d'un émetteur-récepteur sans fil IEEE802.11b/IEEE802.11g/IEEE802.11n, il utilise la technologie
radio DSSS (Modulation du spectre à séquence directe) / OFDM (Multiplexage par répartition orthogonale de la
fréquence). En tant que tel, il est étudié pour fonctionner sans problèmes avec n’importe quel autre produit sans fils
supportant la norme DSSS/OFDM qui:
est conforme à la norme IEEE 802.11b/IEEE802.11g/IEEE802.11n relative aux réseaux locaux sans fil, telle que
définie et approuvée par l’IEEE (Institute of Electrical and Electronics Engineers).
est certifié Wi-Fi® CERTIFIED™ par l’Alliance Wi-Fi®.
Consignes à respecter
Sauf accord écrit explicite et préalable de Technicolor, vous ne pouvez pas:
démonter, décompiler, décomposer, examiner ou analyser de quelque manière que ce soit l'appareil, son contenu,
son fonctionnement ou ses fonctionnalités,
ni tenter de copier le code source (ou les concepts sous-jacents, les algorithmes, la structure ou l'organisation) de
l'appareil,
ou de toute autre information fournie par Technicolor, sauf si cette restriction est expressément interdite par la
législation locale;
copier, louer, prêter, revendre, mettre sous licence, ni transférer ou distribuer l'appareil à des tiers;
modifier, adapter ou créer un dérivé de l'appareil;
retirer de l'appareil l'identification du produit, les droits d'auteur ou toute autre notification;
diffuser des informations ou analyses relatives aux performances de l'appareil (y compris et sans restriction, les tests
de performance) quelle que soit la source d'information.
Ces actes, réalisés sans l'accord explicite de Technicolor, entraînent la perte de la garantie du produit et enlèvent à
l'utilisateur le droit d'employer l'équipement.
Technicolor rejette toute responsabilité en cas d'utilisation de l'équipement non conforme aux présentes instructions.
!
Afin d’éviter tout risque d’incendie, de choc électrique et de blessure corporelle, il convient d’utiliser le produit
conformément aux mesures de sécurité de base, parmi lesquelles les suivantes:
Respectez toujours les instructions d’installation détaillées dans la documentation accompagnant le
produit.
Évitez de connecter ou d'utiliser ce produit en cas d'orage.La foudre peut provoquer un faible risque de
choc électrique.
N’utilisez pas le produit pour signaler une fuite de gaz à proximité de cette fuite.

Rate

3.5 / 5 based on 2 votes.

Popular Technicolor Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top