Page 98
501 SE Columbia Shores Boulevard, Suite 500, Vancouver, Washington 98661, USA
l
+1 360 859 1780
SmartRG Inc. Propriety and Confidential. All Rights Reserved. Copyright © 2014
smartrg.com
Field Name
Description
a client device with its 40MHz Intolerant bit set is detected. Disabling this feature
violates the 802.11-2012 specification.
RX power chain save
[Enable, Disable] Turn on power save mode.
Note: 802.11n/EWC must be set to Auto before enabling this feature.
RX power chain save quiet time
[0 to 2147483647 seconds] Set the delay time between when system activity ceases
and power save mode engages.
Note: Set 802.11n/EWC to Auto and to Enable before setting this parameter.
RX power chain save PPS
[0 to 2147483647 packets per second] Sets a throughput threshold for when the
router engages power save mode after the quiet time seconds have elapsed.
Note: Set 802.11n/EWC to Auto and to Enable before setting this parameter.
54g rate
[Auto, 11 Mbps, 1 Mbps, 2 Mbps, 5.5 Mbps, 11 Mbps] Select a fixed data rate from the
drop-down list if desired. Auto will select 11 Mbps when possible but will drop (based
on signal strength) when necessary.
Multicast rate
[1-54 Mbps] Enter the desired packet transmit rate for multicast.
Basic Rate Fragmentation Threshold
[256 - 2346 bytes]
Enter the threshold for what sized packets will be fragmented to a
smaller unit size. The primary consideration for this setting being the size/capability
of the circuit.
A high packet error rate is an indication that a slightly increased Fragmentation
Threshold is in order.
When possible, the default value of 2346 should be main-
tained. Poor throughput is a likely result of setting this threshold too low.
RTS Threshold
[256 – 2346 bytes] Specify the Request to Send packet size beyond which the WLAN
client hardware invokes its RTS/CTS mechanism. Smaller packets will otherwise be
sent not using RTS/CTS.
The threshold is off when using the default setting of 2347.
DTIM Interval
[1 and 65535] a.k.a. Beacon rate, Delivery Traffic Indication Message is a countdown
variable indicating when the next window for listening to buffered broadcast and
multicast messages is available to client devices.
The default is 1.
Beacon Interval
[1 and 65535 ms]
The time interval between beacon transmissions. Beacon transmissions
make known the presence of an access point and convey to wireless NICs when to
awake from power save mode to check for buffered frames at the access point).
The default is 100 ms.
19216811.live