10

SAGEM F@st

TM

1704

Router supervision

The HTTP configuration tool lets you configure and monitor the router remotely.

To access the HTTP configuration tool:

1.

Open your browser.

2.

Enter the router’s IP address or enter the following URL: http://myrouter

3.

In the login screen that appears, enter your username and password.

The welcome page of the HTTP configuration tool appears.

The router’s activity status is always visible at the top right corner.

You can perform the following actions:

•

click on

Refresh

to update the data displayed

•

click on

Reboot

to restart your router

ADSL information

The following table presents the possible states of the

ADSL

field:

The

Down

field displays the nominal downlink bit rate.

The

Up

field displays the nominal uplink bit rate.

Note

This information is provided by your

I

nternet

S

ervice

P

rovider (ISP).

Status

Meaning

Green

ADSL line synchronised

Yellow

ADSL line synchronising

Red

ADSL line not connected

11

SAGEM F@st

TM

1704

Internet information

The following table presents the possible states of the

Internet

field:

Status

Message

Meaning

Off

Adsl Down

ADSL line not connected or not activated

Not configured

The Internet account must be configured

Router rebooting

Router is rebooting

Green

Connected

The Internet account is configured

Yellow

Waiting for ISP

ADSL line synchronising

Red

Access denied

Incorrect Internet account

12

SAGEM F@st

TM

1704

6.

Advanced router configuration

Use the HTTP configuration tool to access advanced router settings and configure your equipment

according to your needs.

Example of an advanced Wi-Fi configuration:

13

SAGEM F@st

TM

1704

7. Troubleshooting

Many sources of information are available to help you identify and resolve issues you may experience:

•

the LEDs on the front panel of the router (see

Status of the LEDs on the front panel

, page 9),

•

the HTTP configuration tool (see

Router supervision

, page 10).

For step-by-step and advanced problem-solving procedures, use the

Diagnostic tool

available in the

HTTP configuration tool.

If none of the above helps you solve the problem, and you are still having trouble connecting to the

Internet, we recommend that you restart your router and eventually reset the factory configuration. You

will then need to re-configure your router as a first-time setup.

Diagnostics tool

To access the Diagnostic tool:

1.

Open the configuration tool (see

Router supervision

, page 10).

2.

Select the

Diagnostics

menu.

3.

Click on

Test

. The Internet connection is tested step-by-step:

•

successful tests are marked as a pass.

•

unsuccessful tests are marked as a fail.

4.

If a test fails, click on the corresponding

Help

link to access detailed information and problem-solving

procedures.

5.

Click on

Test

to check the problem is solved and resume the connection tests.

Note

Status DOWN means that an interface was not detected (LAN or

Wi-Fi).

14

SAGEM F@st

TM

1704

Restarting your router

To restart your router, use one of the following methods:

•

press the

Power

button located on the rear panel of the router,

•

click on the

Reboot

action of the HTTP configuration tool (see

Router supervision

, page 10).

Resetting factory configuration

To reset the default settings and therefore restore the router to its factory configuration, use one of the

following methods:

•

press and hold for about 10 seconds the

Reset

button located on the rear panel of the router,

•

in the HTTP configuration tool, select

Management

>

Settings

>

Restore default

.