Page 31 / 101
Scroll up to view Page 26 - 30
If the
WPA Mode
is set to
Auto (WPA or WPA2)-Enterprise
, the page as shown
in the following figure appears:
You need to enter the IP address, port, shared key of the RADIUS server.
Click
Apply
to save the settings.
WPA2 Only
25
Page 32 / 101
If the
Security Mode
is set to
WPA2 only
, the page as shown in the following
figure appears:
Parameters in this page are similar to those in the page for
Auto (WPA or
WPA2)
.
Click
Apply
to save the settings.
WPA Only
If the
Security Mode
is set to
WPA only
, the page as shown in the following
figure appears:
26
Page 33 / 101
Parameters in this page are similar to those in the page for
Auto (WPA or
WPA2)
.
Click
Apply
to save the settings.
3.2.4
Local Network
You can configure the LAN IP address according to the actual application. The
preset IP address is
192.168.1.1. You can use the default settings and DHCP
service to manage the IP settings of the private network. The IP address of the
device is the base address used for DHCP. To use the device for DHCP in your
27
Page 34 / 101
28
LAN, the IP address pool used for DHCP must be compatible with the IP address
of the device. The IP address available in the DHCP IP address pool changes
automatically if the IP address of the device changes.
You can also enable the secondary LAN IP address. The primary and the
secondary LAN IP addresses must be in different network segments.
Choose
Setup
>
Local Network
. The
LOCAL NETWORK
page as shown in the
following figure appears:
Page 35 / 101
29
By default,
Enable DHCP Server
is selected for the LAN interface of the device.
DHCP service provides IP settings to workstations configured to automatically
obtain IP settings that are connected to the device through the Ethernet port.
19216811.live