Page 26 / 101
Scroll up to view Page 21 - 25
In this page, you can configure the parameters of wireless LAN clients that may
connect to the device.
The following table describes the parameters in this page.
Field
Description
Enable Wireless
Select or deselect the check box to enable or disable
the wireless function.
Enable MultiAP
Isolation
Select or deselect the check box to enable or disable
multiAP isolation. If this function is enabled, clients of
different SSIDs cannot access each other.
Wireless Network
Name (SSID)
Network name. It can contain up to 32 characters. It
can consist of letters, numerals, and/or underlines.
Visibility Status
°
Visible
indicates that the device broadcasts the
SSID.
°
Invisible
indicates that the device does not
broadcast the SSID.
Channel
You can select from the drop-down list:
FCC(1-11)
,
ETS(1-13)
,
JP(1-14)
Channel Number
Select the wireless channel used by the device from
the drop-down list. You can select
Auto Scan
or a
20
Page 27 / 101
Field
Description
value from
CH1
—
CH13
.
Auto Scan
is recommended.
802.11 Mode
Select the 802.11 mode of the device from the
drop-down list. The device supports 802.11b, 802.11g,
802.11n, 802.11b/g, 802.11n/g, and 802.11b/g/n.
Band Width
You can set the bandwidth only in the 802.11n mode.
You can set the bandwidth of the device to
20M
or
40M
.
Click
Apply
to save the settings.
3.2.3.2 Wireless Security
In the
WIRELESS SETTINGS
page, click
Wireless Security
. The page as
shown in the following figure appears:
Wireless security is vital to your network to protect the wireless communication
among wireless stations, access points and the wired network. This device
provides the following encryption modes:
None
,
WEP
,
Auto (WPA or WPA2)
,
WPA2 Only
, and
WPA Only
.
WEP
If the
Security Mode
is set to
WEP
, the page as shown in the following figure
appears:
21
Page 28 / 101
.
The following table describes the parameters in this page.
Field
Description
WEP Key Length
You can select
64 bits
or
128 bits
from the drop-down
list.
°
If you select
64 bits
, you need to enter 10
hexadecimal numbers or 5 characters.
22
Page 29 / 101
23
Field
Description
°
If you select
128 bits
, you need to enter 26
hexadecimal numbers or 13 characters.
Choose WEP Key
Select the WEP key from the drop-down list. Its value
range is 1
—
4.
WEP Keys 1
—
4
Set the 64 bits or 128 bits key, in the format of Hex or
ASCII.
Authentication
Select the authentication mode from the drop-down list.
You can select
Open
or
Share Key
.
Click
Apply
to save the settings.
Auto (WPA or WPA2)
If the
Security Mode
is set to
Auto (WPA or WPA2)
, the page as shown in the
following figure appears:
Page 30 / 101
The following table describes the parameters in this page.
Field
Description
WPA Mode
You can select
Auto (WPA or WPA2)-PSK
or
Auto
(WPA or WPA2)-Enterprise
from the drop-down list.
Group Key Update
Interval
Set the interval for updating the key.
Pre-Shared Key
Set the preshared key to identify the workstation.
24
19216811.live