Page 56 / 74
Scroll up to view Page 51 - 55
WF-2409
User Manual
Figure 4-42
¾
Authentications type: The default is set to “Auto”, which allows “Open System” or
“Shared Key” authentication to be used. Select “Shared Key” if you only want to use
“Shared Key” authentication (the sender and recipient use a WEP key for authentication).
¾
Beacon Interval: The interval time of this 300Mbps Wireless-N Router broadcast a beacon.
Beacon is used to synchronize the wireless network. The valid interval is 20-1000, the
default is 100.
¾
RTS Threshold: You can set RTS Threshold value in this field, the valid range should be
256-2347 and default value is 2347. If a network packet is smaller than the preset RTS
threshold size, the RTS/CTS mechanism will not be enabled.
¾
Aggregation: You can accelerate the wireless transmission speed by enabling the
aggregation function. The default is AMPDU
＋
AMSDU.
¾
Fragmentation Threshold: It specifies the maximum size of packet during the
fragmentation of data to be transmitted.
¾
Transmission Rate: Transmit rate indicates the transmission speed of wireless LAN
access .The default setting is “Auto” and you can set this value between 1-54Mbps range.
¾
Protection: Using 802.11b and 802.11g mixed mode may result in poor network
performance. By enabling 802.11 protection, it will ameliorate performance of 802.11g
devices in your wireless network.
55
Page 57 / 74
WF-2409
User Manual
¾
Preamble Type: "Short Preamble" is suitable for heavy traffic wireless network. "Long
Preamble" provides much communication reliability; the default setting is "Long
Preamble”.
4.5.7.
Multiple AP Settings
The default status of secondary AP is disab le, you can select enable to enable the secondary
AP. Please refer to “Quick Setup” and “Wireless Security” for details.
Figure 4-43
4.6.
QoS
4.6.1.
QoS Settings
Figure 4-44
56
Page 58 / 74
WF-2409
User Manual
Figure 4-45
¾
Intelligent QoS Status: QoS switch.
¾
WAN line bandwidth:WAN bandwidth control
¾
Status: Application priority setup control.
¾
Priority: use a number to define the application priority,The smaller number has higher
priority
¾
LAN host: Set the LAN host IP, you can define “all Host”,”Specific Host”,”Host subnet”
or “HOST IP section”
¾
WAN host: Set the LAN host IP,the same setting as LAN Host
¾
Templates: define a application setup Templates
57
Page 59 / 74
WF-2409
User Manual
4.6.2.
Host Bandwidth control
Figure 4-46
¾
Uplink Speed: set host uplink bandwidth
¾
Downlink Speed: set host downlink bandwidth
¾
Maximum connection numbers: set the Maximum connection numbers
¾
IP Address: Set the IP address range for restricted hosts.
58
Page 60 / 74
WF-2409
User Manual
4.7.
Forwarding
4.7.1.
Virtual Servers
Figure 4-47
¾
Description: Describe current virtual server item
¾
Internal Host IP Address: The “Internal Host IP Address” indicates IP address of the
internal host using virtual server.
¾
Templates: The templates item supplies several protocols. For example, if you have web
server within LAN, you can select the HTTP template then the router will input port
number 80 automatically.
¾
External Port: Input an extranet port number (the users in Internet can see these ports).
¾
Internal Port: Input an intranet port number.
4.7.2.
FTP
This item set the FTP application port.
59
19216811.live