WF-2409

User Manual

following picture appears

Figure 4-22

3. The next is the safe connection between the adapter and the router, please wait

4. The connect between the adapter and the router is success

Method 5:

1. Select ‘Input PIN from AP’ in WI-FI protect setup page, input PIN of the router, then click

‘PIN Input Config (PIN)’

Figure 4-23

2. Select this router in the pop-up window, then click ‘Select’

Figure 4-24

40

WF-2409

User Manual

3. Please wait until the following window appears, the connect between the adapter and the

router will connect automatically

Figure 4-25

Remark

If there is more than one AP in the PBC mode when you use the method 1/2/4, there will be

session overlap. Please using method 3/5 or wait for a while push the button again.

4.4.

Network

4.4.1.

WAN

This item provides two access types for you to configure the WAN parameters.

41

WF-2409

User Manual

Figure 4-26

¾

IP address: The IP address you obtained after connect to the Internet, if you haven’t

connected to the Internet yet, this field is 0.0.0.0.

¾

Subnet Mask: The Subnet mask you obtained after connect to the Internet, if you haven’t

connected to Internet yet, this field is 0.0.0.0.

¾

Default Gateway: The IP address of Default gateway you obtained after connect to the

Internet, if you haven’t connected to Internet yet, this field is 0.0.0.0.

¾

MTU: The MTU (Maximum Transmission Unit) setting specifies the largest packet size

permitted for network transmission. Most DSL users should use the value 1492.You can

set MTU manually, and you should leave this value in the 1200 to 1500 range. If the value

you set is not in accord with the value ISP provide, it may causes some problems, such as

fail to send Email, or fail to browse website. So if that happen, you can contact your ISP for

more information and correct your router’s MTU value.

¾

Primary DNS: The DNS server translates domain or website names into IP address, input

the most common DNS server address you used or provided by your ISP.

¾

Secondary DNS: Input IP address of a backup DNS server or you can leave this field

blank.

4.4.2.

LAN

The IP address of LAN port is used for access router itself by computers that connect to the

router directly; here you can set IP address you need. The IP address format is like

***.***.***.***, and default IP address is 192.168.1.1, the default subnet mask is

255.255.255.0.

42

WF-2409

User Manual

Figure 4-27

4.4.3.

DHCP

Figure 4-28

¾

DHCP Server Status

Keep the default setting “Enable”, so router is able to use DHCP function. If a DHCP server has

already existed in the network, please select “Disable”.

¾

IP Address Pool

The IP Address pool is used for allocate IP address by DHCP server; The IP Address pool range

is also changeable

43

WF-2409

User Manual

4.4.4.

Port settings

Show current running information of Interface Mode, Default settings is auto.

Figure 4-29

4.5.

Wireless

4.5.1.

Wireless Basic

Providing basic configuration items for wireless router users, including “wireless network

status”, “SSID”, “Radio Band”, “Radio Mode”, “MAC”, “SSID broadcasting”, “Channel

width”, “Channel sideband”, “Region” and “Channel” several basic configuration items.

44