19216811.liveTroubleshooting
376
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Test the Path from Your Computer to a Remote Device
After verifying that the LAN path works correctly, test the path from your computer to a remote
device. From the Windows Run dialog box, type:
ping -n 10 <IP address>
in which
<IP address>
is the IP address of a remote device such as your ISP’s DNS
server.
If the path is functioning correctly, replies as in the previous section are displayed. If you do
not receive replies:
•
Check that your computer has the IP address of your wireless VPN firewall listed as the
default gateway. If the IP configuration of your computer is assigned by DHCP, this
information is not visible in your computer’s Network Control Panel.
•
Check to see that the network address of your computer (the portion of the IP address
that is specified by the netmask) is different from the network address of the remote
device.
•
Check that the modem, dish, or router is connected and functioning.
•
For IPv4 connections, if your ISP assigned a host name, system name, or account name
to your computer, enter that name in the Account Name field on the Broadband ISP
Settings (IPv4) screen. You might also have to enter the assigned domain name or
workgroup name in the Domain Name field, and you might have to enter additional
information. For more information, see
Manually Configure an IPv4 Internet Connection
on page 31.
•
Your ISP could be rejecting the Ethernet MAC addresses of all but one of your computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address of
your broadband modem, but some ISPs additionally restrict access to the MAC address
of a single computer connected to that modem. If this is the case, you need to configure
your wireless VPN firewall to
clone
or
spoof
the MAC address from the authorized
computer. You can do this in the Router’s MAC Address section on the WAN Advanced
Options screen. For more information, see
Configure Advanced WAN Options and Other
Tasks
on page 47.
Restore the Default Configuration and Password
To reset the wireless VPN firewall to the original factory default settings, you can use
one of the following two methods:
•
Press the factory default
Reset
button on the rear panel of the wireless VPN firewall (see
Rear Panel
on page 18) and hold the button for about 8 seconds until the Test LED turns
on and begins to blink (about 30 seconds). To restore the factory default settings when
you do not know the administration password or IP address, you need to use the factory
default Reset button method.
•
Use the Default button on the Settings Backup and Firmware Upgrade screen:
a.
Select
Administration > Settings Backup and Firmware Upgrade
: