Page 51 / 86
Scroll up to view Page 46 - 50
3G9W - HSPA 7.2Mbps Wi-Fi Router USER GUIDE
YML902 – 51
Options
Description
Filter Name
The filter rule label
Protocol
TCP, TCP/UDP, UDP or ICMP
Source IP address
Enter source IP address
Source Subnet Mask
Enter source subnet mask
Source Port
(port or port:port)
Enter source port number or port range
Destination IP address
Enter destination IP address
Destination Subnet Mask
Enter destination subnet mask
Destination port
(port or port:port)
Enter destination port number or range
Click
Save/Apply
to save and activate the filter.
Incoming IP Filter
The default setting for all Incoming traffic is
BLOCKED
.
Under this condition only those incoming IP packets
that match the filter rules will be
ACCEPTED
.
To add a filtering rule, click the
Add
button. The following screen will display.
Please refer to the Outgoing IP Filter table for field descriptions.
Click
Save/Apply
to save and activate the filter.
Downloaded from
www.Manualslib.com
manuals search engine
Page 52 / 86
52 – YML902
7.3.2
Parental Control
This Parental Control allows you to restrict access from a Local Area Network (LAN)
to an outside network
through the Router on selected days at certain times.
Make sure to activate the Internet Time server
synchronization as described in section 6.3 SNTP, so that the scheduled times match your local time.
Click Add to display the following screen.
See instructions below and click
Save/Apply
to apply the settings.
Options
Description
User Name
A user-defined label for this restriction
Browser’s MAC Address
MAC address of the PC running the browser
Other MAC Address
MAC address of another LAN device
Days of the Week
The days the restrictions apply.
Start Blocking Time
The time the restrictions start
End Blocking Time
The time the restrictions end.
Downloaded from
www.Manualslib.com
manuals search engine
Page 53 / 86
3G9W - HSPA 7.2Mbps Wi-Fi Router USER GUIDE
YML902 – 53
7.4
Routing
Default Gateway
,
Static Route
and
Dynamic Route
settings can be found in the Routing link as
illustrated below.
7.4.1
Default Gateway
If the
Enable Automatic Assigned Default Gateway
checkbox is selected, this device will accept a default
Gateway assignment.
If the checkbox is not selected, a field will appear allowing you to enter the static default
gateway and/or WAN interface, then click
Save/Apply
.
NOTE:
After enabling the Automatic Assigned Default Gateway, you must re-boot the Router to activate the assigned default Gateway.
Downloaded from
www.Manualslib.com
manuals search engine
Page 54 / 86
54 – YML902
7.4.2
Static Route
The Static Route screen displays the configured static routes.
Click the Add or Remove buttons to change settings.
Click the Add button to display the following screen.
Enter Destination Network Address, Subnet Mask, Gateway IP Address and/or WAN Interface.
Then click
Save/Apply to add the entry to the routing table.
Downloaded from
www.Manualslib.com
manuals search engine
Page 55 / 86
3G9W - HSPA 7.2Mbps Wi-Fi Router USER GUIDE
YML902 – 55
7.4.3
Dynamic Route
To activate this option, select the Enabled radio button for Global RIP Mode.
To configure an individual interface, select the desired RIP version and operation, followed by placing a check
in the Enabled checkbox for that interface.
Click Save/Apply to save the configuration and to start or stop
dynamic routing.
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live