Page 91 / 116
Scroll up to view Page 86 - 90
TELSTRA TURBO 7 WIRELESS GATEWAY (3G10WVT) - USER GUIDE
91
FOR WINDOWS VISTA
1.
Open a web-browser (such as Internet Explorer,Firefox or Safari)
2.
Type in the address“\\NetbiosName\DirectoryName\”
(eg \\ntc-cpe\ntc-cpe)
Note:
There is no username and password required to access the USB drive. Any network user will be able to read/write the
folder/files in the USB drive.
Page 92 / 116
TELSTRA TURBO 7 WIRELESS GATEWAY (3G10WVT) - USER GUIDE
9±
APPENDIX C :CLI COMMANDS
VIA TELNET
Show all CLI commands
Description:List all available CLI commands that the 3G gateway supports.
Synopsis:help | ?
Example:
> help
?
help
logout
reboot
ddns
dumpcfg
arp
defaultgateway
dhcpserver
dns
lan
passwd
remoteaccess
restoredefault
route
save
ping
sntp
sysinfo
tftp
wlan
sierra
version
build
Page 93 / 116
TELSTRA TURBO 7 WIRELESS GATEWAY (3G10WVT) - USER GUIDE
93
serialnumber
End the telnet session
Description:End the telnet session
Synopsis:logout
Example:
> logout
Reset/reboot device
Description:To reboot the gateway.
Synopsis:reboot
Example:
> reboot
Radio Signal Strength
Description:Display the 3G radio signal strength.
Synopsis:sierra show --signal
Example:
> sierra show --signal
signal:23
Note: Signal value is explain in the table below
Page 94 / 116
TELSTRA TURBO 7 WIRELESS GATEWAY (3G10WVT) - USER GUIDE
94
Radio Band
Description:Display the 3G band
Synopsis:sierra show --band
Example:
> sierra show --band
band:IMT2000
Note:IMT2000 is band 2100 and WCDMA800 is band 850
Connection status
Description:Display the 3G network connection status
Synopsis:sierra show –link
sierra show --gstatus
Examples:
> sierra show --link
link:Connected
> sierra show --gstatus
Current Time:450 Temperature:45
Bootup Time:1 Mode:ONLINE
System mode:WCDMA PS state:Attached
WCDMA band:WCDMA800 GSM band:Unknown
WCDMA channel:4436 GSM channel:65535
GMM (PS) state:REGISTERED NORMAL SERVICE
MM (CS) state:IDLE NORMAL SERVICE
WCDMA L1 State:L1M_FACH RRC State:CELL_FACH
RX level (dBm):-90
Page 95 / 116
TELSTRA TURBO 7 WIRELESS GATEWAY (3G10WVT) - USER GUIDE
95
IMSI & IMEI read
Description:Display the IMSI and IMEI value
Synopsis:sierra show --imsi
sierra show --imei
Example:
> sierra show --imsi
imsi:466974800524867
> sierra show --imei
IMEI:354219010024303
Network Information
•
sierra show --hsdcat
Description:To indicate the current HSDPA category.
Synopsis:sierra show --hsdcat
Example:
> sierra show --hsdcat
!HSDCAT:8
•
sierra show --hsucat
Description:To indicate the current HSUPA category.
Synopsis:sierra show --hsucat
Example:
> sierra show --hsucat
!HSUCAT:5
•
sierra show --mode
Description:To report the current available and supported network technologies being used.
Synopsis:sierra show --mode
Example:
> sierra show --mode
mode:UMTS
(Valid values:“GSM”,“GPRS”,“EDGE”,“UMTS”,“HSDPA”,“HSUPA”)