MediaLink MWN-WAPR150N Router Manual PDF (Setup & Configuration Guide)

Home

Manuals

MediaLink

MWN-WAPR150N

Page 56 / 76 Scroll up to view Page 51 - 55

MWN-WAPR150N Wireless Router

Chapter 9 Traffic Control

9.1 Traffic Control

Traffic control is used to limit communication speed in the

LAN and WAN. Up to 20 entries can be supported with the

capability for at most 254 PCs' speed control, including IP

address range configuration.

Enable Traffic Control:

To enable or disable the

internal IP bandwidth control. The default is disabled.

Interface:

To limit the uploading and downloading

bandwidth in WAN port.

Service:

To select the controlled service type, such as

HTTP service.

IP Starting Address:

The first IP address for traffic

Page 57 / 76

MWN-WAPR150N Wireless Router

control.

IP Ending Address:

The last IP address for traffic

control.

Uploading/Downloading:

To specify the traffic

heading way for the selected IP addresses: uploading or

downloading.

Bandwidth:

To specify the uploading/downloading Min.

/Max. Traffic speed (KB/s), which can not exceed the

WAN speed.

Apply:

To enable the current editing rule. If not, the rule

will be disabled.

Add:

After editing the rule, click the “Add” button to add

the current rule to rule list.

Apply:

Click “Apply” to activate the current rule.

Cancel:

Click “Cancel” to cancel.

Page 58 / 76

MWN-WAPR150N Wireless Router

Chapter 10 Security Settings

10.1 Client Filter Settings

Control and limit specific computers and devices on the

network from accessing the internet at specific times of the

day.

The example below shows a policy that blocks the IP

addresses from 192.168.0.100 to 120 from accessing the

internet Sunday through Thursday 9pm to 5:30am.

Page 59 / 76

MWN-WAPR150N Wireless Router

Client Filter:

Check to enable client filter.

Access Policy:

Select one number from the drop-down

menu. Set up to 10 rules (policies).

Enable:

Check to enable the access policy.

Clear the Policy:

Click “Clear” button to clear all

settings for the policy.

Filter Mode:

Click one radio button to enable or disable

to access the Internet.

Policy Name:

Enter a name for the access policy

selected.

IP Start/End:

Enter the starting/ending IP address for

the computer/device you want the policy to apply to.

You must have manually assigned IP addresses to the

clients you wish to control or else the client’s IP address

will change when the lease runs out.

Port No.:

Enter the port range based over the protocol

for access policy. If you don’t know the specific Ports you

want to block, enter 1~99999 to block them all.

Protocol:

Select one protocol (TCP/UDP/Both) from the

drop-down menu. If you’re unsure, select “Both”

Times:

Select the time range of client filter.

Days:

Select the day(s) to run the access policy.

10.2 URL Filter Settings

Page 60 / 76

MWN-WAPR150N Wireless Router

Limit or control the websites that can be accessed by specific

computers/devices on the network.

URL Filter:

Check to enable URL filter.

Access Policy:

Select one number from the drop-down

menu.

Enable:

Check to enable the access policy.

Clear the Policy:

Click “Clear” button to clear all

settings for the policy.

Filter Mode:

Click one radio button to enable or disable

to access the Internet.

Policy Name:

Enter a name for the access policy

selected.

Start/End IP:

Enter the starting/ending IP address.

Rate

Popular MediaLink Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share