1. Home
    2. /
  2. Manuals
    3. /
  3. Linksys
    4. /
  4. SPA-3102
    5. /
  5. 9
Page 41 / 100 Scroll up to view Page 36 - 40
Voice Gateway with Router
33
Chapter 6: Using the Web-based Utility
The Voice Tab
RTP Bytes Sent
. Displayed here is the number of RTP bytes sent by the Voice Gateway.
RTP Packets Recv
. Displayed here is the number of RTP packets received by the Voice Gateway.
RTP Bytes Recv
. Displayed here is the number of RTP bytes received by the Voice Gateway.
SIP Messages Sent
. Displayed here is the number of SIP messages sent by the Voice Gateway.
SIP Bytes Sent
. Displayed here is the number of SIP bytes sent by the Voice Gateway.
SIP Messages Recv
. Displayed here is the number of SIP messages received by the Voice Gateway.
SIP Bytes Recv
. Displayed here is the number of SIP bytes received by the Voice Gateway.
External IP
. Displayed here is the external IP address used for NAT mapping.
Line 1 Status
Hook State
. Displayed here is the status of the Internet phone line’s readiness.
On
indicates that it is ready for
use, while
Off
indicates that it is in use.
Registration State
. Shown here is the status of the line’s registration with the ITSP.
Last Registration At
. Shown here are the last date and time the line was registered.
Next Registration In
. Shown here is the number of seconds until the next registration.
Message Waiting
. This indicates whether you have new voicemail waiting.
Call Back Active
. This indicates whether a call back request is in progress.
Figure 6-9: Line 1 Status
Downloaded from
www.Manualslib.com
manuals search engine
Page 42 / 100
Voice Gateway with Router
34
Chapter 6: Using the Web-based Utility
The Voice Tab
Last Called Number
. Displayed here is the last number called.
Last Caller Number
. Displayed here is the number of the last caller.
Mapped SIP Port
. Shown here is the port number of the NAT mapped SIP port.
Calls 1 and 2 have the same status information available.
Call 1/2 State
. Displayed here is the status of the call.
Call 1/2 Tone
. Displayed here is the type of tone used by the call.
Call 1/2 Encoder
. Displayed here is the codec used for encoding.
Call 1/2 Decoder
. Displayed here is the codec used for decoding.
Call 1/2 FAX
. Displayed here is the status of the fax pass-through mode.
Call 1/2 Type
. Displayed here is the direction of the call.
Call 1/2 Remote Hold
. This indicates whether the far end has placed the call on hold.
Call 1/2 Callback
. This indicates whether the call was triggered by a call back request.
Call 1/2 Peer Name
. Displayed here is the name of the internal phone.
Call 1/2 Peer Phone
. Displayed here is the phone number of the internal phone.
Call 1/2 Duration
. Displayed here is the duration of the call.
Call 1/2 Packets Sent
. Displayed here is the number of packets sent.
Downloaded from
www.Manualslib.com
manuals search engine
Page 43 / 100
Voice Gateway with Router
35
Chapter 6: Using the Web-based Utility
The Voice Tab
Call 1/2 Packets Recv
. Displayed here is the number of packets received.
Call 1/2 Bytes Sent
. Displayed here is the number of bytes sent.
Call 1/2 Bytes Recv
. Displayed here is the number of bytes received.
Call 1/2 Decode Latency
. Displayed here is the number of milliseconds for decoder latency.
Call 1/2 Jitter
. Displayed here is the number of milliseconds for receiver jitter.
Call 1/2 Round Trip Delay
. Displayed here is the number of milliseconds for delay.
Call 1/2 Packets Lost
. Displayed here is the number of packets lost.
Call 1/2 Packet Error
. Displayed here is the number of invalid packets received.
Call 1/2 Mapped RTP Port
. Displayed here is the number of the NAT mapped RTP port.
PSTN Line Status
Hook State
. Displayed here is the status of the LINE port.
On
indicates that it is ready for use, while
Off
indicates that it is in use.
Line Voltage
. Displayed here is the tip-to-ring voltage of the LINE port.
Loop Current
. Displayed is the loop current to the LINE port.
Registration State
. Shown here is the status of the line’s registration.
Last Registration At
. Shown here are the last date and time the line was registered.
Figure 6-10: PSTN Line Status
Downloaded from
www.Manualslib.com
manuals search engine
Page 44 / 100
Voice Gateway with Router
36
Chapter 6: Using the Web-based Utility
The Voice Tab
Next Registration In
. Shown here is the number of seconds until the next registration.
Last Called VoIP Number
. VoIP stands for Voice over Internet Protocol, which is used by Internet phone calls.
Displayed here is the last Internet phone number called from the landline.
Last Called PSTN Number
. Displayed here is the last landline number dialed by the Voice Gateway.
Last VoIP Caller
. The VoIP caller is the one who calls the Voice Gateway via VoIP to obtain traditional phone
service. Displayed here is the number of the last VoIP caller.
Last PSTN Caller
. The PSTN caller is the one who calls the Voice Gateway from the traditional phone service to
obtain VoIP service. Displayed here are the name and number of the last PSTN caller.
Last PSTN Disconnect Reason
. Displayed here is why the Voice Gateway terminated the LINE port connection.
PSTN Activity Timer
. Displayed here is the number of milliseconds before the Voice Gateway disconnects the
current gateway unless the landline has some audio activity.
Mapped SIP Port
. Shown here is the port number of the NAT mapped SIP port.
Call Type
. Displayed here is the direction of the call.
VoIP State
. Displayed here is the status of Line 1, Call 1.
PSTN State
. Displayed here is the status of the PSTN call.
VoIP Tone
. Displayed here is the tone playing to the VoIP call leg.
PSTN Tone
. Displayed here is the tone playing to the PSTN call leg.
Downloaded from
www.Manualslib.com
manuals search engine
Page 45 / 100
Voice Gateway with Router
37
Chapter 6: Using the Web-based Utility
The Voice Tab
VoIP Peer Name
. Displayed here is the name of the party at the VoIP call leg.
PSTN Peer Name
. Displayed here is the name of the party at the PSTN call leg.
VoIP Peer Number
. Displayed here is the phone number of the party at the VoIP call leg.
PSTN Peer Number
. Displayed here is the phone number of the party at the PSTN call leg.
The following are the same as the status information for Line 1, Call 1 in the Line 1 Status section.
VoIP Call Encoder
. Displayed here is the codec used for encoding the VoIP call leg.
VoIP Call Decoder
. Displayed here is the codec used for decoding the VoIP call leg.
VoIP Call FAX
. Displayed here is the status of the fax pass-through mode.
VoIP Call Remote Hold
. This indicates whether the far end has placed the call on hold.
VoIP Call Duration
. Displayed here is the duration of the call.
VoIP Call Packets Sent
. Displayed here is the number of packets sent.
VoIP Call Packets Recv
. Displayed here is the number of packets received.
VoIP Call Bytes Sent
. Displayed here is the number of bytes sent.
VoIP Call Bytes Recv
. Displayed here is the number of bytes received.
VoIP Call Decode Latency
. Displayed here is the number of milliseconds for decoder latency.
VoIP Call Jitter
. Displayed here is the number of milliseconds for receiver jitter.
Downloaded from
www.Manualslib.com
manuals search engine

Rate

4.5 / 5 based on 2 votes.

Popular Linksys Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top