Page 111 / 127
Scroll up to view Page 106 - 110
100
Appendix D: Physical Setup of the Router
Setting up the Router
10/100 16-Port VPN Router
Appendix D: Physical Setup of the Router
This section describes the physical setup of the Router, including installation of the mounting brackets.
Setting up the Router
You can set the Router on a desktop, install it in a rack with attached brackets, or mount it on the wall.
Placement of the Router
Set the Router on a desktop or other flat, secure surface. Do not place excessive weight on top of the Router that
could damage the Router.
Rack-Mounting the Router
The Router comes with two brackets and eight screws for mounting on a 19-inch rack. The attached brackets are
shown in Figure D-1.
Figure D-1: Mounting Brackets
Downloaded from
www.Manualslib.com
manuals search engine
Page 112 / 127
101
Appendix D: Physical Setup of the Router
Setting up the Router
10/100 16-Port VPN Router
Line up the bracket holes with the holes located on the Router’s sides. Attach the mounting brackets using the
included screws, four on each side of the Router.
When the brackets are attached to the Router, you can rack-mount it. Attach the Router to the rack, using two
screws on each side of the Router, as shown below in Figure D-2.
Figure D-2: Attaching the Brackets to the Router and Rack-Mounting the Router
Downloaded from
www.Manualslib.com
manuals search engine
Page 113 / 127
102
Appendix D: Physical Setup of the Router
Setting up the Router
10/100 16-Port VPN Router
Wall-Mounting the Router
The Router is shown in Figure D-3 with two holes on the bottom. The horizontal distance between the two holes
is 3.701 inches (94 mm). Install two screws or nails into the wall, 3.701 inches (94 mm) apart. After the screws or
nails are secured on the wall, line up the Router’s holes with the screws or nails, and mount the Router on the
wall. The wall-mount holes are shown below, in Figure D-3. The suggested mounting hardware is shown in
Figure D-4.
Figure D-3: Wall-Mounting the Router
Downloaded from
www.Manualslib.com
manuals search engine
Page 114 / 127
103
Appendix D: Physical Setup of the Router
Setting up the Router
10/100 16-Port VPN Router
Figure D-4: Wall-Mounting Hardware
Downloaded from
www.Manualslib.com
manuals search engine
Page 115 / 127
104
Appendix E: Battery Replacement
Replacing a Lithium Battery
10/100 16-Port VPN Router
Appendix E: Battery Replacement
Replacing a Lithium Battery
The Router has a lithium battery, number CR2032, on its main circuit board. This battery has an operating life of
about one to two years. When the battery loses its charge, the Router cannot update the correct time except
when connected to the NTP Server.
Do not attempt to replace this battery yourself. You must call Linksys Technical Support to replace the battery.
Danger of explosion exists if the lithium battery is incorrectly replaced. The battery can only be replaced with the
same or equivalent type of CR2032 lithium battery.
WARNING:
The lithium battery can explode if replaced
incorrectly. It must be replaced with an equivalent CR2032
lithium battery. Do not replace this battery yourself. Contact
Linksys Technical Support.
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live