Page 76 / 109
Scroll up to view Page 71 - 75
66
4.15
Blocked Protocols
Click the
Blocked Protocols
of
Advanced Function
in the
Wizard Column to set the Blocked Protocols. The MT800 is capable
of sending and receiving information in a variety of protocol formats.
The Blocked Protocols feature enables you to prevent the MT800
from passing any data that uses a particular protocol. Unlike the IP
Filter feature, you cannot specify additional criteria for blocked
protocols, such as particular users or destinations. However, when
you are certain that a particular protocol is not needed or wanted on
your network, this feature provides a convenient way to discard such
data before it is passed.
I.
Configuration page
Figure 4-32
Blocked protocols
To block a protocol, click the appropriate check box.
Page 77 / 109
67
II.
Save
z
Click the
Submit
button to save the settings in the RAM.
z
To save these configuration changes permanently, enter
the
Save & Reboot
page, select
Save
and click
Submit
button to save new settings.
4.16
Diagnostics
The diagnostics feature executes a series of test of your system
software and hardware connections. Use this feature when working
with your ISP to solve problems. Click the
Diagnostics
of
Advance
Function
in the Wizard column to perform the basic diagnostics for
system.
Figure 4-33
Diagnostics window
Page 78 / 109
68
Select the Virtual Circuit and click the
Submit
button. A
message will appear, informing you whether the loop test succeeded
or failed.
The diagnostics utility will run a series of test to check whether
the device's connections are up and working. This takes only a few
seconds. The program reports whether the test passed or failed. A
test may be skipped if the program determines that no suitable
interface is configured on which to run the test.
4.17
Access Management
4.17.1
User Management
The first time you log into the Web Configuration Manager, use
the default user ID and password (admin and admin).
Figure 4-34
Access management
I.
Change the password
For the default user ID, admin, only the password can be
changed. The method to change the password of admin or users is
described as below:
Page 79 / 109
69
Figure 4-35
User Config-Modify
Perform the following steps to change the password:
2)
Open the Access Management page;
3)
Enter the configuration page
User Config-Modify
by click
the
in the operation column;
4)
Enter the new password, confirm the password and
submit.
Save the setting in the
Save & Reboot
page and then restart
the system to take effect the setting.
±
Note:
It is recommended to keep a record of the new password after modified.
Page 80 / 109
70
II.
Add new user
To add new user ID and password, click the
Add
Button in
Access Management
page, log into the
User Configuration-Add
page.
Figure 4-36
User config - add
z
User ID:
This lists the current User ID (user name).
z
Privilege:
Root – can access and modify system configurations
User – can read limited configurations.
z
Password:
Type in the new password.
z
Confirm Password:
Type in the new password a second
time for confirmation.
If you need to delete a user, click the icon
in the operation
column that the user located to delete the user.
19216811.live