Page 21 / 112 Scroll up to view Page 16 - 20
User Manual
EchoLife HG520 Home Gateway
Chapter 3
Preparing Configuration
Huawei Technologies Proprietary
10
Figure 3-2
HG520 Home Page
Page 22 / 112
User Manual
EchoLife HG520 Home Gateway
Chapter 4
Quick Setup
Huawei Technologies Proprietary
11
Chapter 4
Quick Setup
The system administrator can configure HG520 remotely or
locally through a Web Browser. Network configuration needs to be
planned and decided before the configuration procedure is started.
Quick Setup allows system administrator to select the
appropriate operation mode and configure the corresponding settings
step by step to create a connection. The following five operation
modes are supported:
z
PPP over Ethernet (PPPoE)
z
IP over ATM (IPoA)
z
Bridging
z
MAC Encapsulation Routing (MER)
z
PPP over ATM (PPPoA)
4.1
Configuring
PPPoE
Click on <Quick Setup> in the left frame, and follow the steps
below to create a PPPoE connection.
Page 23 / 112
User Manual
EchoLife HG520 Home Gateway
Chapter 4
Quick Setup
Huawei Technologies Proprietary
12
I.
ATM PVC Configuration
Figure 4-1
Quick Setup – ATM PVC Configuration
1)
Enter the VPI/VCI values. The actual parameter is provided
by your ISPs, and you can contact them to get the detailed
information.
2)
Disable “DSL Auto-connect” .
3)
Check to enable QoS.
4)
Click on <Next> to go to next step.
Page 24 / 112
User Manual
EchoLife HG520 Home Gateway
Chapter 4
Quick Setup
Huawei Technologies Proprietary
13
II.
Connection Type and Encapsulation Mode Configuration
Figure 4-2
Quick Setup – Connection Type and Encapsulation
Mode
1)
Select
“PPP
over
Ethernet
(PPPoE)”,
and
the
“Encapsulation Mode”. The actual parameter is provided by
your ISPs, and you can contact them to get the detailed
information.
2)
Click on <Next> to go to next step.
Page 25 / 112
User Manual
EchoLife HG520 Home Gateway
Chapter 4
Quick Setup
Huawei Technologies Proprietary
14
III.
PPP Username and Password Configuration
Figure 4-3
Quick Setup – PPP Username and Password
1)
Enter “PPP Username”, “PPP Password”, and select
“Authentication Method” (AUTO/PAP/CHAP). The actual
parameter is provided by your ISPs, and you can contact
them to get the detailed information.
2)
The “Dial on demand” function, if checked, will tear down the
PPP link automatically when there is no outgoing packet for
the programmed period of time that is set below.
3)
The “PPP IP extension” is a special feature provided by
some ISPs. Unless your service provider specifically
requires this setup, do not select it.
4)
Click on <Next> to go to next step.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top