Page 16 / 36
Scroll up to view Page 11 - 15
16
3.
You are configuring the device to work in AP mode. If you have
confirmed the settings, please click the
“
Save
”
button to reboot the
device and activate the configurations.
Page 17 / 36
17
3.4
System Status
3.4.1
System Status
Connected Clients: Display the number of the connected clients.
Display System Version, Firmware Version, and Running Time
Running Time is the total time the Range Extender is turned on.
3.4.2
WAN Status
Connection Type: Displays the current access mode WAN port.
Connection Status: It displays the connection status.
WAN MAC Address: It displays the Adapter
’s
WAN MAC address
WAN IP: IP address obtained from ISP.
Subnet mask: Obtained from ISP.
Gateway: Obtained from ISP.
Page 18 / 36
18
Primary DNS server: Obtained from ISP.
Second DNS server: Obtained from ISP.
Connection Duration: The connection of dynamic IP or PPPOE to router
and ISP is simultaneously timed.
Note: WAN Status only exists in WISP Mode and Router Mode.
3.4.3
LAN Status
IP address: The Router’s LAN IP address (not your PC’s IP address).The
default value is
10.10.10.251;
you can change it when necessary.
Subnet M
ask: The Router’s LAN subnet mask. The default value is
255.255.255.0
DHCP Server: If the router is a DHCP server, it will show as enabled.
Otherwise it will be disabled.
LAN MAC Address: It displays the Adap
ter’s LAN MAC address
.
3.4.4
Wireless Status
This section displays the devices wireless information.
Page 19 / 36
19
3.4.5
Network Status
Operation Mode: It displays the Operation Mode.
Connection Status: It displays the connection status.
Note: Network Status is only shown in the System Status of AP Mode.
3.5
Network Settings
Network Settings are only available in Router Mode and AP Mode. Set
up Network only when system is in Router Mode or AP Mode.
In Router Mode
：
WAN Settings
Page 20 / 36
20
Plug the Internet cable to the HooToo Powerline Adapter WAN port.
Connection Type: It displays the router mode.
MTU: Maximum Transmission Unit. It is the size of the largest data packet
that can be sent over the network. The default value is 1500. Do not
modify it unless necessary. If a specific website or web application
software cannot be opened or enabled, you can try to change the
MTU value from 1500 to 1400, etc.
WAN Parameters
Negotiation Mode: You can set the value to match the status.
Note:
Default is auto.
Your WAN port cable may be old or too long which means the
drive might not be powerful enough. You may also find that your
19216811.live