Page 91 / 108
Scroll up to view Page 86 - 90
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
91
Backup Settings:
This can save the current Broadband router configuration to a file
named "
config.bin
" on your PC. You can also use the
<Upload>
button to restore
the saved configuration to the Broadband router. Alternatively, you can use the
"
Restore to Factory Defaults
" tool to force the Broadband router to perform a
power reset and restore the original factory settings.
-
Reset
You can reset the broadband router when system stops responding correctly or stop
functions.
Page 92 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
92
XIII -
Repeater Mode
Repeater mode has limited settings compared to the AP mode. Choose “Repeater
mode” on the top right corner of the configuration page.
You will see the configuration homepage under “
REPEATER
” mode now.
Page 93 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
93
System
-
Status
System status section allows you to monitor the current status of your router.
You can see the Uptime, hardware information, serial number as well as firmware
version information.
LAN Settings:
This page displays the Broadband router LAN port’s current LAN
information.
WLAN
Settings:
Wireless
configuration
details
such
as
SSID,
Status(Connected/Disconnected), Security and Channel are briefly shown.
Page 94 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
94
-
LAN
The LAN Tabs shows LAN settings. LAN settings can be change as needed. If you
are an entry level user, try opening a website from your computer. If you’re
successful and able to connect and browse the web site you opened without any
problem, do not change any of the settings.
Click
<Apply>
at the bottom of this screen to save the changed configurations.
IP address:
This is the router’s LAN IP address (Your LAN clients default gateway
IP address). It can be changed based on your network architecture.
IP Subnet Mask:
Specify a Subnet Mask IP address for your LAN segment.
802.1d Spanning Tree:
This is disabled by default. If 802.1d Spanning Tree
function is enabled, this router will use the spanning
tree protocol to prevent network loops.
Page 95 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
95
19216811.live