Page 281 / 304
Scroll up to view Page 276 - 280
VigorPro5300 Series User’s Guide
273
Note:
The rate of outbound/inbound must be smaller than the real
bandwidth to ensure correct calculation of QoS. It is suggested to set the
bandwidth value for inbound/outbound as 80% - 85% of physical network
speed provided by ISP to maximize the QoS performance.
4.
Return to previous page. Enter the Name of Index Class 1 by clicking
Edit
link. Type
the name “
E-mail
” for Class 1.
5.
For this index, the user will set reserved bandwidth (e.g., 25%) for
Email
using
protocol POP3 and SMTP.
6.
Return to previous page. Enter the Name of Index Class 2 by clicking
Edit
link. In this
index, the user will set reserved bandwidth (e.g., 25%) for
HTTPS
.
Page 282 / 304
VigorPro5300 Series User’s Guide
274
7.
Click
Setup
link for WAN1.
8.
Check
Enable UDP Bandwidth Control
on the bottom to prevent enormous UDP
traffic of VoIP influent other application, and click OK.
9.
If the worker has connected to the headquarter using host to host VPN tunnel. (Please
refer to Chapter 3 VPN for detail instruction), he may set up an index for it. Enter the
Class Name of Index 3. In this index, he will set reserve bandwidth for 1 VPN tunnel.
Page 283 / 304
VigorPro5300 Series User’s Guide
275
10.
Click edit to open a new window.
11.
First, check the
ACT
box. Then click
Edit
of
Local Address
to set a worker’s subnet
address. Click
Edit
of
Remote Address
to set headquarter’s subnet address. Leave
other fields and click
OK
.
5.4 LAN – Created by Using NAT
An example of default setting and the corresponding deployment are shown below. The
default Vigor router private IP address/Subnet Mask is
192.168.1.1/255.255.255.0. The
built-in DHCP server is enabled so it assigns every local NATed host an IP address of
Page 284 / 304
VigorPro5300 Series User’s Guide
276
You can just set the settings wrapped inside the red rectangles to fit the request of NAT
usage.
To use another DHCP server in the network rather than the built-in one of Vigor Router, you
have to change the settings as show below.
Page 285 / 304
VigorPro5300 Series User’s Guide
277
You can just set the settings wrapped inside the red rectangles to fit the request of NAT
usage.
19216811.live