Page 481 / 794
Scroll up to view Page 476 - 480
Vigor2860 Series User’s Guide
467
4.2 How can I get the files from USB storage device connecting
to Vigor router?
Files on USB storage device can be reviewed by opening
USB Applicaiton>>File Explorer.
If it is necessary for you to delete, copy files on the device or write, paste files to the devcie, it
must be done through SMB server or FTP server.
Samba service is based on the original USB FTP service. You will need to setup USB FTP
first. We would like to give brief instructions on USB FTP setup here.
1.
Plug the USB device to the USB port on the router. Make sure
Disk Connected
appears
on the
Connection Status
as the figure shown below:
2.
Then, please open
USB Application >> USB General Settings
to enable Samba service.
Page 482 / 794
Vigor2860 Series User’s Guide
468
3.
Setup a user account for the FTP service by using
USB Application >>USB User
Management.
Click
Enable
to enable FTP/Samba User account. Here we add a new
account "user1" and assign authorities “Read”, “Write” and “List” to it.
4.
Click
OK
to save the configuration.
5.
Make sure the FTP service is running properly. Please open a browser and type
Use the account "
user1
" to login.
Page 483 / 794
Vigor2860 Series User’s Guide
469
6.
When the following screen appears, it means the FTP service is running properly.
7.
Return to
USB Application >> USB Disk Status
. The information for FTP server will
be shown as below.
Now, users in LAN of Vigor2860 can access into the USB storage device by typing
ftp://192.168.1.1 on any browser. They can add or remove files / directories, depending on the
Access Rule for FTP account settings in
USB Application >>USB User Management.
Page 484 / 794
Vigor2860 Series User’s Guide
470
4.3 How to Build a LAN-to-LAN VPN Between Remote Office and
Headquarter via IPsec Tunnel (Main Mode)
Configuration on Vigor Router for Head Office
1.
Log into the web user interface of Vigor router.
2.
Open
VPN and Remote Access>>LAN to LAN
to create a LAN-to-LAN profile. The
following settings are for a permanent VPN connection.
3.
Click any index number to open the configuration page. Type a name which is easy for
identification for such profile (in this case, type
VPN Server
)
,
and
check the box of
Enable This Profile
. For Vigor router will be set as a
server
, the call direction shall be
set as
Dial-in
and set 0 as
Idle Timeout
.
Page 485 / 794
Vigor2860 Series User’s Guide
471
4.
Now navigate to the next section,
Dial-In Settings
to check PPTP, IPsec Tunnel and
L2TP boxes. Check the box of
Specify Remote…
and type the
Peer VPN Server IP
(e.g., 218.242.130.19 in this case). Press the
IKE Pre-Shared Key
button to set the
PSK
;
and
select
Medium (AH)
or
High (ESP)
as the security method.
5.
Continue to navigate to the
TCP/IP Network Settings
for setting the LAN IP for remote
side.
6.
Click
OK
to save the settings.
19216811.live