Page 461 / 794
Scroll up to view Page 456 - 460
Vigor2860 Series User’s Guide
447
3.20.10 Traffic Graph
Click
Diagnostics
and click
Traffic Graph
to open the web page. Choose
WAN1/WAN2/WAN3/WAN4 Bandwidth, Sessions, daily or weekly for viewing different
traffic graph. Click
Reset
to zero the accumulated RX/TX (received and transmitted) data of
WAN. Click
Refresh
to renew the graph at any time.
The horizontal axis represents time. Yet the vertical axis has different meanings. For
WAN1/WAN2/WAN3/WAN4 Bandwidth chart, the numbers displayed on vertical axis
represent the numbers of the transmitted and received packets in the past.
For Sessions chart, the numbers displayed on vertical axis represent the numbers of the NAT
sessions during the past.
Page 462 / 794
Vigor2860 Series User’s Guide
448
3.20.11 Trace Route
Click
Diagnostics
and click
Trace Route
to
open the web page. This page allows you to trace
the routes from router to the host. Simply type the IP address of the host in the box and click
Run
. The result of route trace will be shown on the screen.
or
Available settings are explained as follows:
Item
Description
IPv4 / IPv6
Click one of them to display corresponding information for
it.
Trace through
Use the drop down list to choose the interface that you want
Page 463 / 794
Vigor2860 Series User’s Guide
449
to ping through.
Protocol
Use the drop down list to choose the protocol that you want
to ping through.
Host/IP Address
It indicates the IP address of the host.
Trace Host/IP Address
It indicates the IPv6 address of the host.
Run
Click this button to start route tracing work.
Clear
Click this link to remove the result on the window.
3.20.12 Syslog Explorer
Such page provides real-time syslog and displays the information on the screen.
For Web Syslog
This page displays the time and message for User/Firewall/call/WAN/VPN settings. You can
check
Enable Web Syslog,
specify the type of Syslog
and choose the display mode you want.
Later, the event of Syslog with specified type will be shown for your reference.
Available settings are explained as follows:
Item
Description
Enable Web Syslog
Check this box to enable the function of Web Syslog.
Syslog Type
Use the drop down list to specify a type of Syslog to be
displayed.
Export
Click this link to save the data as a file.
Refresh
Click this link to refresh this page manually.
Clear
Click this link to clear information on this page.
Display Mode
There are two modes for you to choose.
Page 464 / 794
Vigor2860 Series User’s Guide
450
Stop record when fulls –
when the capacity of syslog is
full, the system will stop recording.
Always record the new event –
only the newest events
will be recorded by the system.
Time
Display the time of the event occurred.
Message
Display the information for each event.
For USB Syslog
This page displays the syslog recorded on the USB storage disk.
Available settings are explained as follows:
Item
Description
Time
Display the time of the event occurred.
Log Type
Display the type of the record.
Message
Display the information for each event.
3.20.13 TSPC Status
IPv6 TSPC status web page could help you to diagnose the connection status of TSPC.
If TSPC has configured properly, the router will display the following page when the user
connects to tunnel broker successfully.
Page 465 / 794
Vigor2860 Series User’s Guide
451
Available settings are explained as follows:
Item
Description
Refresh
Click this link to refresh this page manually.
3.20.14 DSL Status
DSL Status web page could help you to diagnose the connection status for DSL.
19216811.live