Page 171 / 202
Scroll up to view Page 166 - 170
Vigor2800 Series User’s Guide
165
2.
Then, for using
PPP based
services, such as PPTP, L2TP, you have to set general
settings in
PPP General Setup
.
For using
IPSec-based
service, such as IPSec or L2TP with IPSec Policy, you have to
set general settings in
IPSec General Setup
, such as the pre-shared key that both
parties have known.
3.
Go to
LAN-to-LAN
. Click on one index number to edit a profile.
4.
Set
Common Settings
as shown below. You should enable both of VPN connections
because any one of the parties may start the VPN connection.
5.
Set
Dial-Out Settings
as shown below to dial to connect to Router B aggressively with
the selected Dial-Out method.
If an
IPSec-based
service is selected, you should further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-Out
connection.
Page 172 / 202
Vigor2800 Series User’s Guide
166
If a
PPP-based
service is selected, you should further specify the remote peer IP
Address, Username, Password, PPP Authentication and VJ Compression for this
Dial-Out connection.
6.
Set
Dial-In settings
to as shown below to allow Router A dial-in to build VPN
connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
Page 173 / 202
Vigor2800 Series User’s Guide
167
If a
PPP-based
service is selected, you should further specify the remote peer IP
Address, Username, Password, and VJ Compression for this Dial-In connection.
7.
At last, set the remote network IP/subnet in
TCP/IP Network Settings
so that Router
B can direct the packets destined to the remote network to Router A via the VPN
connection.
Page 174 / 202
Vigor2800 Series User’s Guide
168
4.2 Create a Remote Dial-in User Connection Between the
Teleworker and Headquarter
The other common case is that you, as a teleworker, may want to connect to the enterprise
network securely. According to the network structure as shown in the below illustration, you
may follow the steps to create a Remote User Profile and install Smart VPN Client on the
remote host.
Settings in VPN Router in the enterprise office:
1.
Go to
VPN and Remote Access
and select
Remote Access Control
to enable the
necessary VPN service and click
OK
.
2.
Then, for using PPP based services, such as PPTP, L2TP, you have to set general
settings in
PPP General Setup
.
For using IPSec-based service, such as IPSec or L2TP with IPSec Policy, you have to
set general settings in
IKE/IPSec General Setup
, such as the pre-shared key that both
parties have known.
Page 175 / 202
Vigor2800 Series User’s Guide
169
3.
Go to
Remote Dial-In Users
. Click on one index number to edit a profile.
4.
Set
Dial-In
settings to as shown below to allow the remote user dial-in to build VPN
connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
If a
PPP-based
service is selected, you should further specify the remote peer IP
Address, Username, Password, and VJ Compression for this Dial-In connection.
19216811.live