Page 246 / 275
Scroll up to view Page 241 - 245
Vigor2110 Series User’s Guide
239
3.
Go to
Remote Dial-In User
. Click on one index number to edit a profile.
4.
Set
Dial-In
settings to as shown below to allow the remote user dial-in to build VPN
connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
If a
PPP-based
service is selected, you should further specify the remote peer IP Address,
Username, Password, and VJ Compression for this Dial-In connection.
Page 247 / 275
Vigor2110 Series User’s Guide
240
Settings in the remote host:
1.
For Win98/ME, you may use "Dial-up Networking" to create the PPTP tunnel to Vigor
router.
For Win2000/XP, please use "Network and Dial-up connections" or “Smart VPN
Client”, complimentary software to help you create PPTP, L2TP, and L2TP over IPSec
tunnel. You can find it in CD-ROM in the package or go to www.draytek.com download
center. Install as instructed.
2.
After successful installation, for the first time user, you should click on the
Step 0.
Configure
button. Reboot the host.
3.
In
Step 2. Connect to VPN Server
, click
Insert
button to add a new entry.
If an IPSec-based service is selected as shown below,
Page 248 / 275
Vigor2110 Series User’s Guide
241
You may further specify the method you use to get IP, the security method, and
authentication method. If the Pre-Shared Key is selected, it should be consistent with the
one set in VPN router.
If a PPP-based service is selected, you should further specify the remote VPN server IP
address, Username, Password, and encryption method. The User Name and Password
should be consistent with the one set up in the VPN router. To use default gateway on
remote network means that all the packets of remote host will be directed to VPN server
then forwarded to Internet. This will make the remote host seem to be working in the
enterprise network.
Page 249 / 275
Vigor2110 Series User’s Guide
242
4.
Click
Connect
button to build connection. When the connection is successful, you will
find a green light on the right down corner.
5.3 QoS Setting Example
Assume a teleworker sometimes works at home and takes care of children. When working
time, he would use Vigor router at home to connect to the server in the headquarter office
downtown via either HTTPS or VPN to check email and access internal database. Meanwhile,
children may chat on Skype in the restroom.
1.
Go to
Bandwidth Management>>Quality of Service.
2.
Click
Setup
link of WAN. Make sure the QoS Control on the left corner is checked. And
select
BOTH
in
Direction
.
Page 250 / 275
Vigor2110 Series User’s Guide
243
3.
Return to previous page. Enter the Name of Index Class 1 by clicking
Edit
link. Type the
name “
E-mail
” for Class 1.
4.
For this index, the user will set reserved bandwidth (e.g., 25%) for
E-mail
using protocol
POP3 and SMTP.
19216811.live