Page 236 / 275
Scroll up to view Page 231 - 235
Vigor2110 Series User’s Guide
229
Clear
Click this link to remove the result on the window.
4.15.8 Trace Route
Click
Diagnostics
and click
Trace Route
to
open the web page. This page allows you to trace
the routes from router to the host. Simply type the IP address of the host in the box and click
Run
. The result of route trace will be shown on the screen.
Protocol
Use the drop down list to choose the interface that you want to ping
through.
Host/IP Address
It indicates the IP address of the host.
Run
Click this button to start route tracing work.
Clear
Click this link to remove the result on the window.
Page 237 / 275
Vigor2110 Series User’s Guide
230
Page 238 / 275
Vigor2110 Series User’s Guide
231
5
A
A
p
p
p
p
l
l
i
i
c
c
a
a
t
t
i
i
o
o
n
n
a
a
n
n
d
d
E
E
x
x
a
a
m
m
p
p
l
l
e
e
s
s
5.1 Create a LAN-to-LAN Connection Between Remote Office
and Headquarter
The most common case is that you may want to connect to network securely, such as the
remote branch office and headquarter. According to the network structure as shown in the
below illustration, you may follow the steps to create a LAN-to-LAN profile. These two
networks (LANs) should NOT have the same network address.
Settings in Router A in headquarter:
1.
Go to
VPN and Remote Access
and select
Remote Access Control
to enable the
necessary VPN service and click
OK
.
2.
Then,
For using
PPP
based services, such as PPTP, L2TP, you have to set general settings in
PPP General Setup
.
For using
IPSec
-based service, such as IPSec or L2TP with IPSec Policy, you have to set
general settings in
IPSec General Setup
, such as the pre-shared key that both parties
Page 239 / 275
Vigor2110 Series User’s Guide
232
have known.
3.
Go to
LAN-to-LAN
. Click on one index number to edit a profile.
4.
Set
Common Settings
as shown below. You should enable both of VPN connections
because any one of the parties may start the VPN connection.
5.
Set
Dial-Out Settings
as shown below to dial to connect to Router B aggressively with
the selected Dial-Out method.
If an
IPSec-based
service is selected, you should further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-Out
connection.
Page 240 / 275
Vigor2110 Series User’s Guide
233
If a
PPP-based service
is selected, you should further specify the remote peer IP Address,
Username, Password, PPP Authentication and VJ Compression for this Dial-Out
connection.
6.
Set
Dial-In settings
to as shown below to allow Router B dial-in to build VPN
connection.
If an
IPSec-based
service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in
IPSec General Setup
above.
19216811.live