Page 311 / 357
Scroll up to view Page 306 - 310
Vigor2830 Series User’s Guide
299
Refresh
Click this link to refresh this page manually.
Index
Display the number of the data flow.
IP Address
Display the IP address of the monitored device.
TX rate (kbps)
Display the transmission speed of the monitored device.
RX rate (kbps)
Display the receiving speed of the monitored device.
Sessions
Display the session number that you specified in Limit Session
web page.
Action
Block
- can prevent specified PC accessing into Internet within
5 minutes.
Unblock
– the device with the IP address will be blocked in
five minutes. The remaining time will be shown on the session
column.
Current /Peak/Speed
Current
means current transmission rate and receiving rate for
WAN interface.
Peak
means the highest peak value detected by the router in
data transmission.
Speed
means line speed specified in
WAN>>General Setup
. If
you do not specify any rate at that page, here will display
Auto
for instead.
Page 312 / 357
Vigor2830 Series User’s Guide
300
4.16.8 Traffic Graph
Click
Diagnostics
and click
Traffic Graph
to pen the web page. Choose
WAN1/WAN2/WAN3 Bandwidth, Sessions, daily or weekly for viewing different traffic
graph. Click
Refresh
to renew the graph at any time.
The horizontal axis represents time. Yet the vertical axis has different meanings. For
WAN1/WAN2/WAN3Bandwidth chart, the numbers displayed on vertical axis represent the
numbers of the transmitted and received packets in the past.
For Sessions chart, the numbers displayed on vertical axis represent the numbers of the NAT
sessions during the past.
Page 313 / 357
Vigor2830 Series User’s Guide
301
4.16.9 Trace Route
Click
Diagnostics
and click
Trace Route
to
open the web page. This page allows you to trace
the routes from router to the host. Simply type the IP address of the host in the box and click
Run
. The result of route trace will be shown on the screen.
Trace through
Use the drop down list to choose the interface that you want to
ping through.
Protocol
Use the drop down list to choose the protocol that you want to
ping through.
Host/IP Address
It indicates the IP address of the host.
Run
Click this button to start route tracing work.
Clear
Click this link to remove the result on the window.
Page 314 / 357
Vigor2830 Series User’s Guide
302
4.16.10 Web Firewall Syslog
Such page provides real-time syslog and displays the information on the screen.
For Web Syslog
This page displays the time and message for User/Firewall/call/WAN/VPN settings. You can
check
Enable Web Syslog,
specify the type of Syslog
and choose the display mode you want.
Later, the event of Syslog with specified type will be shown for your reference.
Enable Web Syslog
Check this box to enable the function of Web Syslog.
Syslog Type
Use the drop down list to specify a type of Syslog to be
displayed.
Display Mode
There are two modes for you to choose.
Stop record when fulls –
when the capacity of syslog is full,
the system will stop recording.
Always record the new event –
only the newest events will be
recorded by the system.
Time
Display the time of the event occurred.
Message
Display the information for each event.
Page 315 / 357
Vigor2830 Series User’s Guide
303
For USB Syslog
This page displays the syslog recorded on the USB storage disk.
Time
Display the time of the event occurred.
Log Type
Display the type of the record.
Message
Display the information for each event.
19216811.live