D-Link DSL-2760U USER’S MANUAL
39
Step 3 - PPPoA
PPP Username:
PPP Password:
Authentication Method:
Enable Fullcone NAT:
Enable NAT:
Enable Firewall:
Keep Alive PPP
connection:
LCP echo interval
(seconds):
IP fragmentation low
threshold:
IP fragmentation high
threshold
IP fragmentation time
(seconds):
Dial on demand:
PPP IP extension:
Static IPv4 Address:
IPv4 Address:
PPP Debug Mode:
IGMP Multicast Proxy:
MTU:
PPP Username and Password:
Enter the PPP Account Username here.
Enter the PPP Account Password here.
Choose an Authentication Method. If you don’t know the
Authentication Method, leave this on Auto.
Tick to enable Fullcone NAT
Tick this option to enable NAT for this connection.
Tick this option to enable firewall for this connection.
Tick the option to enable keep alive function of PPP
connection.
Enter a time in second to determine how often to send an
echo message to an idle link.
The lowest threshold value for the LCP packet.
The highest threshold value for the LCP packet
Enter a time in second for IP fragmentation time.
Tick to enable Dial on Demand.
Tick to enable PPP IP Extension.
Tick to enable Static IP version 4 address.
The option appears when
Use Static IPv4 Address
is
selected. Enter the Static IP version 4 address used here.
Tick to enable PPP Debug Mode.
Tick to enable IGMP Multicast Proxy.
Enter a maximum transmission unit value here.
Click
Next
to continue the setup.
19216811.live