The Wide Area Network (WAN) Service Setup page can be used to setup services regarding the WAN interface. The WAN interface on this router is the DSL port
side. When setting up the WAN configuration you can choose between various WAN interface connection methods. Before configuring WAN Service, the
information in Layter2 Interface section needs to be configured.
Display:
This window is used to configure the WAN interface. You can
add, delete and modify WAN interfaces on this window.
If you are setting up the WAN interface for the first time, click
the
Add
button.
Make sure Layer2 Interface is configured before clicking the
Add
button.
Add:
WAN Service Interface Configuration – Select Interface:
Select a
Layer 2 Interface
for this service from the drop-down
menu, and click the
Next
button.
Page 28 / 128
D-Link DSL-2760U USER’S MANUAL
28
PPP over Ethernet
Step 1:
WAN Service Configuration – PPPoE:
To setup a PPPoE Interface select the
PPP over Ethernet
(PPPoE)
and click the
Next
button.
The Service Description will be added automatically.
Page 29 / 128
D-Link DSL-2760U USER’S MANUAL
29
Step 2 - PPPoE:
PPP Username:
PPP Password:
PPPoE Service Name:
Authentication Method:
Enable Fullcone NAT:
Enable NAT:
Enable Firewall:
Keep Alive PPP
connection:
LCP echo interval
(seconds):
IP fragmentation low
threshold:
IP fragmentation high
threshold
IP fragmentation time
(seconds):
Dial on demand:
PPP IP extension:
Static IPv4 Address:
IPv4 Address:
PPP Debug Mode:
Bridge PPPoE:
IGMP Multicast Proxy:
MTU:
Enter the PPP Account Username here.
Enter the PPP Account Password here.
Type in a Service Name here.
Choose an Authentication Method. If you don’t know the
Authentication Method, leave this on Auto.
Tick to enable Fullcone NAT
Tick this option to enable NAT for this connection.
Tick this option to enable firewall for this connection.
Tick the option to enable keep alive function of PPP
connection.
Enter a time in second to determine how often to send an
echo message to an idle link.
The lowest threshold value for the LCP packet.
The highest threshold value for the LCP packet
Enter a time in second for IP fragmentation time.
Tick to enable Dial on Demand.
Tick to enable PPP IP Extension.
Tick to enable Static IP version 4 address.
The option appears when
Use Static IPv4 Address
is
selected. Enter the Static IP version 4 address used here.
Tick to enable PPP Debug Mode.
Tick to bridge of PPPoE frames between the WAN interface
19216811.live