Page 26 / 97 Scroll up to view Page 21 - 25
26
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 6 - Setup
Dial on demand
(with idle
timeout timer):
PPP IP extension:
Use Static IPv4
Address:
Retry
PPP
password on
authentication
error:
Enable PPP
Debug Mode:
Bridge
PPPoE
Frames Between
WAN and
Local Ports:
Enable IGMP
Multicast:
Enable VLAN:
Allows you to manually connect to the Internet so you are not permanently connected.
Idle timeout timer is included.
Used by some ISPs. Check with your ISP to see if it is required.
Select if your ISP has provided you with a static IP address.
If selected, you will be asked to enter the static IP address.
Select if you want the router to automatically retry your PPP username and password when there is an authentication error on
your DSL line.
Select if you want to keep a log of connection negotiation transactions.
This option is used for troubleshooting connection issues.
Use the default setting unless otherwise instructed by your ISP.
Use the default setting unless otherwise instructed by your ISP.
Use the default setting unless otherwise instructed by your ISP.
Page 27 / 97
27
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 6 - Setup
DNS Server Configuration
If
Obtain DNS Server address automatically
is selected, this router accepts the first received DNS assignment from the PPPoE enabled PVC during
the connection establishment.
If
Use the following DNS server addresses
is selected, enter the primary and secondary (optional) DNS server IP addresses
Page 28 / 97
28
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 6 - Setup
Default Gateway
From this page, you can select a preferred WAN interface as the system default gateway.
Page 29 / 97
29
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 6 - Setup
Setup Summary (PPPoE)
Confirm the settings on this page match the settings provided by your ISP.
To make any changes, click
Back
.
If your settings are correct, click
Apply
.
Note:
After clicking
Apply
, you will have to reboot the router in order to activate your connection
Page 30 / 97
30
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 6 - Setup
MAC Encapsulation Routing or DHCP
This page allows you to configure your MER/DHCP connection. Use default settings unless otherwise instructed by your ISP.
This might include
using a static IP address.
In such a case, select Use the following Static IP address and enter your static IP address as provided by your ISP.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top