Page 6 / 97
Scroll up to view Page 1 - 5
6
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 1 - General Information
Front Panel View
1
Power LED
•
A solid green light indicates the unit is powered on.
•
A red light indicates a malfunction.
2
LAN LEDs
•
A solid light indicates a connection to an Ethernet-enabled computer on ports
1-4. This LED blinks during
data transmission.
3
Wireless LED
•
A solid green light indicates the wireless function is operating correctly. A
flashing green light indicates wireless traffic is passing through the router.
4
DSL LED
•
A solid light indicates the DSL is synchronized.
•
A flashing LED indicates the modem is attempting to synchronize with the DSL
provider.
5
Internet LED
•
A solid green light indicates that the modem has an IP address and is connected
to the Internet.
•
A red light indicates that the modem does not have an IP address or authentication
has failed.
•
No light indicates that an ADSL connection is not present or the modem is in
bridge mode.
1
2
4
5
3
Page 7 / 97
7
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 1 - General Information
Rear Panel View
1
2
3
4
5
6
1
DSL Line
•
Connect to an active telephone line (RJ-11).
2
LAN Ports (1-4)
•
Connect Ethernet devices such as computers, switches, and hubs.
3
Wireless ON/OFF
•
Pressing this button to turn the Wireless feature on or off.
4
Reset
•
Pressing the Reset button for 10
seconds restores the modem to its original factory
default settings.
5
ON/OFF
•
Press this button to turn the unit on or off.
6
Power Receptor
•
Receptor for the supplied power adapter.
Page 8 / 97
8
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 1 - General Information
Angle View
1
WPS Button
•
Press this button to add your device to an existing network or to create a new
network.
1
Page 9 / 97
9
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 2 - Installing The Router
Installing the Router
Connect the ADSL and Telephone Lines
• Connect an RJ-11 cable between the wall phone jack and the
ADSL
port on the rear panel of the router.
Connect the PC to the Router
• To use the Ethernet connection, connect the Ethernet cable from the computer directly to the router. Connect one end of the
Ethernet cable to the port labeled
LAN
on the back of the router and attach the other end to the Ethernet port of your computer.
• If your LAN has more than one computer, you can attach one end of an Ethernet cable to a hub or a switch and the other to the
Ethernet port (labeled LAN) on the router. Note that either a crossover or straight-through Ethernet cable can be used. The router
automatically recognizes the type of connection that is required.
Page 10 / 97
10
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Section 2 - Installing The Router
Connect the Power Adapter
• Complete the process by connecting the supplied 12VAC, 1A power adapter to the POWER connector on the back of the device
and plug the adapter into a wall outlet or power strip. Then turn on and boot up your PC and any LAN devices, such as hubs or
switches, and any computers connected to them.
19216811.live