Appendix A – Troubleshooting

D-Link DSL-2640U User Manual

21

Statistics

To access the Router’s first

Statistics

window, click the

Statistics

button in the

Device Info

directory.

This window displays the Router’s LAN statistics. Click the

Reset

Statistics

button to refresh these statistics.

This window displays the Router’s WAN statistics. Click the

Reset

Statistics

button to refresh these statistics.

This window displays the Router’s ATM statistics. Click the

Reset

button

to refresh these statistics.

Appendix A – Troubleshooting

D-Link DSL-2640U User Manual

22

This window displays the Router’s ADSL statistics. Click the

Reset

Statistics

button to refresh these statistics.

Click the

ADSL BER Test

button to access the ADSL Bit Error Rate Test

window displayed below:

Appendix A – Troubleshooting

D-Link DSL-2640U User Manual

23

Route

To access the

Device Info – Route

window, click the

Route

button in the

Device Info

directory.

This read-only window displays routing info.

ARP

To access the

Device Info – ARP

window, click the

ARP

button in the

Device Info

directory.

This read-only window displays Address Resolution Protocol info.

DHCP

To access the

Device Info – DHCP Leases

window, click the

DHCP

button in the

Device Info

directory.

This read-only window displays DHCP lease info.

Appendix A – Troubleshooting

D-Link DSL-2640U User Manual

24

Quick Setup

This chapter is concerned with using your computer to configure the WAN connection. The following chapter describes the various windows used to

configure and monitor the Router including how to change IP settings and DHCP server setup.

QUICK SETUP

Click the

Quick

Setup

link on the left panel of the opening page to launch

a series of setup windows.

Tick the DSL Auto-connect check box and then click the

Next

button.

If the ADSL connection is down, deselect the

DSL Auto-connect

checkbox and then click the

Next

button to manually assign VPI and VCI

values.

Appendix A – Troubleshooting

D-Link DSL-2640U User Manual

25

QUICK SETUP

This window allows you to set up ATM PVC configuration. Enter a Port

Identifier, Virtual Path Identifier, and Virtual Channel Identifier. The VPI

and VCI values should be provided by your ISP. This window also allows

you to enable QoS by ticking the Enable Quality of Service check box.

Click the

Next

button to continue.

QUICK SETUP – CONNECTION TYPE

This window allows you to select the appropriate connection type. The

choices include PPP over ATM (PPPoA), PPP over Ethernet (PPPoE),

MAC Encapsulation Routing (MER), IP over ATM (IPoA), and Bridging

(default).

This window also allows you to use the drop-down menu to select the

desired Encapsulation Mode. Click the

Next

button to continue.