Page 16 / 109
Scroll up to view Page 11 - 15
16
If your ISP uses
PPPoE
(Point-to-Point Protocol over
Ethernet), and this option is
selected, then this screen will
appear: (Used mainly for DSL
Internet service.)
Enter in the username and
password provided to you by
your ISP.
Using the Setup Wizard (continued)
Please be sure to remove any
existing PPPoE client software
installed on your computers.
Click
Next
Click
Restart
Downloaded from
www.Manualslib.com
manuals search engine
Page 17 / 109
17
Using the Configuration Menu
Whenever you want to configure your network or the DI-704UP, you can access the
Configuration Menu by opening the web-browser and typing in the IP Address of the DI-
704UP.
The DI-704UP default IP Address is shown below:
Open the web browser.
Type in the
IP Address
of
the DI-704UP.
Home > Wizard
Note: If you have changed the default IP Address assigned to the DI-704UP, make sure to
enter the correct IP Address.
The factory default
User name
is
“admin”
and the default
Password
is blank (empty).
It is recommended
that you change the admin password
for security purposes.
Please refer to
Tools>Admin
to change the admin
password.
Downloaded from
www.Manualslib.com
manuals search engine
Page 18 / 109
18
The
Home>Wizard
screen will appear upon log in.
Please refer to the
Quick Instal-
lation Guide
for more information regarding the Setup Wizard.
Using the Configuration Menu (continued)
Clicking
Apply
will save changes made to the page.
Clicking
Cancel
will clear changes made to the page.
Clicking
Help
will bring up helpful information regarding the page.
Clicking
Restart
will restart the router.
(Necessary for some changes.)
Home > Wizard (continued)
Downloaded from
www.Manualslib.com
manuals search engine
Page 19 / 109
19
Using the Configuration Menu (continued)
Home > WAN (continued)
WAN is short for Wide Area Network. The WAN settings can be referred to as the
Public settings. All IP information in the WAN settings are public IP addresses which
are accessible on the Internet. The WAN settings consist of four options:
Dynamic IP
Address
,
Static IP Address
,
PPPoE, and Others
. Select the appropriate option and fill
in the information needed to connect to your ISP.
Choose
Dynamic IP Address
to obtain IP address information automatically from your
ISP. Select this option if your ISP does not give you any IP numbers to use. This option
is commonly used for Cable modem services.
Host Name:
The Host Name field is
optional but may be required by some ISPs. The host name is the device name of the
Broadband Router.
Downloaded from
www.Manualslib.com
manuals search engine
Page 20 / 109
20
MAC Address:
The default MAC address is set to the WAN’s physical interface MAC address on the
Broadband Router. You can use the “Clone MAC Address” button to copy the MAC
address of the Ethernet Card installed by your ISP and replace the WAN MAC
address with this MAC address. It is not recommended that you change the default
MAC address unless required by your ISP.
Primary/Secondary DNS Address:
Enter a DNS Address if you do not wish to use the one provided by your ISP.
MTU:
Only enter the MTU if it is required by your ISP. Otherwise, leave it
at the default setting of 1500.
Auto-reconnect:
If enabled, the Broadband Router will automatically connect to your ISP after your
system is restarted or if the connection is dropped.
Using the Configuration Menu (continued)
Home > WAN (continued)
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live