Page 41 / 78
Scroll up to view Page 36 - 40
41
DCS-G900 User’s Manual
D-Link Systems, Inc.
Installing the DCS-G900 Behind a Router
Assigning and Opening Virtual Server Ports
2) Open Virtual Server Ports To Enable Remote Image Viewing
The Virtual Server Ports of your router must be opened for remote access to your camera.
This is also referred to as port forwarding. Please proceed as follows:
• Select
Enabled
to enable virtual server settings.
• Select a camera name.
• Enter your camera’s Local IP Address in the
Private IP
field.
• Select
TCP
under
Protocol Type
.
• If you are using the default camera port settings, enter
80
in to the
Public
and
Private
Port
section.
• Schedule should be set to
Always
so that the camera images can be accessed at any
time.
• In the
Virtual Servers List
, a check mark appearing before the camera name will indicate
that the ports are enabled.
• Click
Apply
to save your settings.
Note:
If you are installing multiple cameras, be sure to open ONE Web port per additional
camera installed: port 81, 82, etc. for Web server.
Page 42 / 78
42
DCS-G900 User’s Manual
D-Link Systems, Inc.
Installing the DCS-G900 Behind a Router
Viewing Your Camera
After all settings have been entered correctly, a user inside or outside your network will have
access to the camera through a standard Web browser. To access from the Internet, simply
type in the IP Address of the router given to you by your ISP, a colon, and the port number
local (home) network, simply enter the local IP Address of your camera (i.e.
192.168.0.35).
If using a port other than port 80, you must enter the IP address followed by a colon and the
assigned port number.
Page 43 / 78
43
DCS-G900 User’s Manual
D-Link Systems, Inc.
IPView SE Application Installation
IPView SE software is included for administrators to manage up to 4 DCS-G900s remotely.
Administrators can also record to hard drive and configure advanced settings for the
DCS-G900. IPView SE is a complete software management tool for the DCS-G900 and
includes all configurable settings available in the web configuration utility.
Insert the CD-ROM into the CD-ROM drive. A menu screen will appear as shown below.
IPView SE Application Installation
Click
Install Software
Click
Install IPView SE
Page 44 / 78
44
DCS-G900 User’s Manual
D-Link Systems, Inc.
IPView SE Application Installation
Click
Yes
Click
Next
Click
Next
Page 45 / 78
45
DCS-G900 User’s Manual
D-Link Systems, Inc.
IPView SE Application Installation
Click
Finish
After successfully installing the IPView SE, the application program for the DCS-G900 is
automatically installed to \Programs\IPView SE Directory.
To start running the IPView SE click on Windows
®
Start > Programs > IPView SE >
IPView SE.
Once the IPView SE application control panel is executed, the interface will appear:
19216811.live