19216811.live6
Connections
Ethernet Cable Connector
The
DCS-2000
back panel features an
RJ-45
connector for connections to
10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling. This network
port supports the
NWay protocol
, allowing the Internet Camera to automatically
detect or negotiate the transmission speed of the network.
Reset Button
Reset will be initiated when the reset button is pressed once and held until the
Power LED flashes through its cycle twice.
Ethernet Cable
Connector
DC Power Connector
I/O Connector
Reset Button
DC Power Connector
The DC power input connector is located on the
DCS-2000
Internet Camera’s
back panel and is labeled
DC 12V
with a single socket to supply power to the
Internet Camera.
Factory reset will be initiated when the reset button is pressed continuously
for 5 seconds or when the Power LED changes from
green
to
red
for 2
cycles. (For example you will see the LED turn to
red
twice, release the
reset button when the LED turns red the second time). The Power LED will
begin to flash indicating that the Internet Camera’s settings are reverting
back to the factory settings, then turn back to
green
.
To reset the camera,
press the reset button once, and the LED will flash to
orange
.
The Ethernet cable included with the DCS-2000 Internet
Camera is a Category 5
“straight through” cable.
This is
the recommended cable type when the camera is
connected to a 100 Mbps Fast Ethernet network hub or
switch.