3.3 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory.

The default values are

shown below.

IP address

192.168.1.254

Subnet Mask

255.255.255.0

DHCP server function

Enabled

IP addresses for

distribution to PCs

100 IP addresses continuing from

192.168.1.100 through

192.168.1.199

The PPPoE function is

enabled

to

automatically get the

WAN port

configuration from the

ISP, but you have to

set the username and

password first.

3.4 Information from your ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider)

what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.

Gather the information as illustrated in the following table and keep it for reference.

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password,

Service Name, and Domain Name System (DNS) IP address (it can

be automatically assigned by your ISP when you connect or be set

manually).

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password,

and Domain Name System (DNS) IP address (it can be

automatically assigned by your ISP when you connect or be set

manually).

VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode.

VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet

mask, Gateway address, and Domain Name System (DNS) IP

address (it is fixed IP address).

24

3.5 Configuring with your Web Browser

Open your web browser, enter the IP address of your router, which by default is

192.168.1.254

, and click “

Go

”, a user name and password window prompt will appear.

The

default username and password are “admin” and “admin”.

Congratulation! You are now successfully logon to the ADSL2+ Modem/Router!

25

Chapter 4

Configuration

At the configuration homepage, the left navigation pane where bookmarks are provided links

you directly to the desired setup page, including:

Quick Start

(wizard setup)

Interface Setup

(Internet, LAN)

Advanced Setup

(Firewall, Routing, NAT, ADSL)

Access Management

(ACL, IP Filter, SNMP, UPnP, DDNS)

Maintenance

(Administration, Time Zone, Firmware, SysRestart, Diagnositics)

Status

Please see the relevant sections of this manual for detailed instructions on how to configure

your Billion router.

26

4.1 Quick Start

For detailed instructions on configuring WAN settings, see the

Interface Setup

section of

this manual.

The information you need for the Quick Start to get you online are your login (often in the

form of

username@ispname

), your password, and the encapsulation type.

The following is the Quick Start step, please follow according to the instruction step by step.

27

Step1.

Set your new password.

Step2:

Choose your time zone

28