Page 66 / 139
Scroll up to view Page 61 - 65
63
4.
The client’s SSID and security setting will now be configured to match the SSID and security
setting of the registrar.
Page 67 / 139
64
PIN Method: Configure AP as Enrollee
1.
In the WPS configuration page, change the Role to Enrollee. Then press Start.
2.
Jot down the WPS PIN (eg. 25879810).
3.
Launch the wireless client’s WPS utility (eg. Ralink Utility). Set the Config Mode as Registrar.
Enter the PIN number in the PIN Code column then choose the correct AP (eg. wlan-ap) from
the WPS AP List section before pressing the PIN button to run the scan.
Page 68 / 139
65
4.
The router’s (AP’s) SSID and security setting will now be configured to match the SSID and
security setting of the registrar.
Page 69 / 139
66
5.
Now to make sure that the setup is correctly done, cross check to see if the SSID and the security
setting of the registrar setting match with the parameters found on both Wireless Configuration
and Wireless Security Configuration page.
Page 70 / 139
67
The parameters on both Wireless Configuration and Wireless Security Configuration page are as
follows:
19216811.live