Page 61 / 90
Scroll up to view Page 56 - 60
User Manual
Page 61
of 90
Untrusted Mode
Untrusted is the default Ingress page setting for all interfaces. In this mode, no domain
mapping is honored in the router. All packets are treated as CoS6 (best effort).
Untrusted mode
Untrusted mode
Untrusted mode
Untrusted mode
Page 62 / 90
User Manual
Page 62
of 90
Layer 2
Layer 2 allows you to map an incoming packet with VLAN priority to CoS. This feature is
only configurable on the WAN interfaces as VLAN is only supported on the WAN side in
the current software release.
Layer 2
Layer 2
Layer 2
Layer 2
Page 63 / 90
User Manual
Page 63
of 90
Layer 3
The Layer 3 page allows you to map ToS bits of incoming packets from the IP network to
CoS for each WAN/LAN interface.
Layer 3
Layer 3
Layer 3
Layer 3
Page 64 / 90
User Manual
Page 64
of 90
Static
The Ingress - Static page enables you to configure a static CoS for all packets received on
a WAN or LAN interface.
Static
Static
Static
Static
Page 65 / 90
User Manual
Page 65
of 90
QoS Shaper Configuration
The Shaper Configuration page is accessed by selecting Shaper on the Advanced main
page. Three shaper algorithms are supported:
°
HTB
°
Low Latency Queue Discipline
°
PRIOWRR
QoS Shaper Configuration
QoS Shaper Configuration
QoS Shaper Configuration
QoS Shaper Configuration
Note:
Note:
Note:
Note:
Egress TCA is required if shaper is configured for that interface.
Of the three shaping algorithms available on the Shaper Configuration page, only one can
be enabled at a time. An example of each configuration is given as follows.
19216811.live