Page 26 / 59
Scroll up to view Page 21 - 25
Click on the Save button when the settings are correct.
The
below screen will appear showing the WAN settings that you
made.
When satisfied with the settings, and no changes are
necessary, click on the Finish button.
To remove any settings,
click on the Remove button.
After selecting the Finish button, the below screen will appear.
At
this point, the router will reboot to save the changes made.
ASUS 4-Port Wireless Ethernet Router
User Manual
25
Version 1.0
Document #:
BD-AU0014-10
Downloaded from
www.Manualslib.com
manuals search engine
Page 27 / 59
LAN Local Area Network (LAN) Setup
You can configure the DSL Router IP address and Subnet Mask
for the LAN interface to correspond your LAN’s IP Subnet. The
Save button only saves the LAN configuration data, but does not
apply the configurations.
Select the Save/Reboot button to save
the LAN configuration data and reboot the router and apply the
new configurations.
NAT
If you enable NAT (Network Address Translation), you can
configure the Virtual Server, Port Triggering, and DMZ Host.
Virtual Servers
ASUS 4-Port Wireless Ethernet Router
User Manual
26
Version 1.0
Document #:
BD-AU0014-10
Downloaded from
www.Manualslib.com
manuals search engine
Page 28 / 59
A virtual server allows you to direct incoming traffic from the WAN
side to a specific IP address on the LAN side.
Select the virtual
server from the drop-down list and complete the server IP
address, then click on the Save / Apply button.
The following screen appears after you save your selection.
To
add additional virtual servers, click on the Add button.
If you need
to remove any of the server names, select the check box and click
on the Remove button.
ASUS 4-Port Wireless Ethernet Router
User Manual
27
Version 1.0
Document #:
BD-AU0014-10
Downloaded from
www.Manualslib.com
manuals search engine
Page 29 / 59
Port Triggering
Click on the Add button to add Port Triggering to your Internet
application.
The below screen appears when you click on Add allowing you to
select the application that you want to set the port settings for.
After a selection has been made, click on the Save / Apply button.
The below screen appears after you save your selections.
You
will be able to add or remove selections made, by clicking on the
Add and Remove buttons.
ASUS 4-Port Wireless Ethernet Router
User Manual
28
Version 1.0
Document #:
BD-AU0014-10
Downloaded from
www.Manualslib.com
manuals search engine
Page 30 / 59
DMZ Host
You can define the IP address of the DMZ Host on this screen.
Enter the IP address and click on Save / Apply.
ALG
The application layer is a window between various application
processes to allow open information exchange. To use the
Application Layer Gateway (ALG), the appropriate Application
Layer Gateway definition was selected in the service configuration
item.
ASUS 4-Port Wireless Ethernet Router
User Manual
29
Version 1.0
Document #:
BD-AU0014-10
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live