Page 106 / 149
Scroll up to view Page 101 - 105
Chapter 8 - Setting Advanced Parameters
MAC Filter
BreezeMAX Si 4000 CPE
92
Operator Manual
8.3
MAC Filter
You can block access to the Internet from clients on the local network by MAC
addresses. In the MAC Filter page you set MAC addresses to be filtered out by the
security system. You can add addresses to the filtered group or delete them, and
also enable or disable filtering at different times.
The following configuration parameters are available:
Select
- Select this check-box to add this row to the filtered group
MAC
- Enter the MAC address to be filtered.
Enabled
- Select this check-box to enable/disable filter for the specific MAC
address
Use the
Add
or
Del
buttons to add the address to the filtered group or clear it from
the group. Click
Apply
to activate your changes.
Figure 8-2: Advance - MAC Filter
Page 107 / 149
Chapter 8 - Setting Advanced Parameters
IP Filter
BreezeMAX Si 4000 CPE
93
Operator Manual
8.4
IP Filter
You can block access to the Internet from clients on the local network by
specifying IP addresses and TCP/UDP port numbers. You can configure up to five
IP filters on the unit.
In the IP Filter page you set IP addresses to be filtered out by the security system.
You can add addresses to the filtered group or delete them. You can also enable or
disable filtering at different times.
The following configuration parameters are available:
Select
- Select this check-box to add this client to the filtered group
IP Range
- Specify an IP address or range on the local network. (Range:
192.168.254.251 to
192.168.254.254)
Port Range
- Enter the port range to be filtered
Protocol
- set the protocol to be filtered: TCP (default) or UDP.
Figure 8-3: Advance - IP Filter
Page 108 / 149
Chapter 8 - Setting Advanced Parameters
IP Filter
BreezeMAX Si 4000 CPE
94
Operator Manual
Enabled
- Select this check-box to enable or disable (default) filtering for the
specific table entry.
Use the
Add
or
Del
buttons to add the address to the filtered group or clear it from
the group. Click
Apply
to activate your changes.
Page 109 / 149
Chapter 8 - Setting Advanced Parameters
Port Forwarding
BreezeMAX Si 4000 CPE
95
Operator Manual
8.5
Port Forwarding
Port Forwarding instructs the router to which computer on the local area network
to send data. According to the port forwarding rules or setup, the router sends the
data from the external IP address: port number to an internal IP address: port
number. Port Forwarding rules are created per port.
The Port Forwarding page enables managing and setup of the rules for Port
Forwarding.
The following configuration parameters are available:
Select
- Select this check-box to add this row to the selection group
Protocol
- Set the protocol for port forwarding: TCP or UDP
WAN Port
- Enter the range (begin and end ports) for the WAN
LAN IP
- Enter the IP address that identifies the IP subnet of the remote
network.
Figure 8-4: Advance - Port Forwarding
Page 110 / 149
Chapter 8 - Setting Advanced Parameters
Port Forwarding
BreezeMAX Si 4000 CPE
96
Operator Manual
Enabled
- Select this check-box to enable/disable port forwarding for the
specific IP
Use the
Add
or
Del
buttons to add a rule to the port forwarding group or clear it
from the group. Click
Apply
to activate your changes.
19216811.live