Page 41 / 138
Scroll up to view Page 36 - 40
BreezeMAX PRO 6000 Product Manual
Chapter 3 - Commissioning
Configuring the Unit Using the WiMAX Modem Application CD
26
3.3
Configuring the Unit Using the WiMAX Modem
Application CD
This section explains how to use the automatic configuration tool, delivered on a CDROM with the unit,
to automatically configure a CPE. This procedure is usually performed by the subscriber.
1
From the CDROM supplied with the unit, run the CPE Auto Configuration Tool:
CPEAutoConfigTool.exe; The Installation Setup Wizard window is displayed.
2
Click
Next
to continue; The Choose Your ISP window is displayed.
To configure the unit using the Auto-Configuration tool:
Figure 3-3: Installation Setup Wizard Window
Page 42 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 3 - Commissioning
Configuring the Unit Using the WiMAX Modem Application CD
27
3
Choose the ISP (Internet Service Provider) ConfigFile from the list and click
Next
. The Ready To Install
window is displayed.
4
Click
Install
. If your CPE is powered up, click
OK
for performing system reboot. If not, power on the
CPE and click
OK
.
The tool starts the auto-configuration process of the unit settings. It will change default settings by
using the *.ipk file, and then run “reset to factory default” by using default configuration in the file.
Figure 3-4: Choose Your ISP Window
Figure 3-5: Ready To Install Window
Page 43 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 3 - Commissioning
Configuring the Unit Using the WiMAX Modem Application CD
28
5
When the installation is complete, an Installation Success window is displayed. Click
OK
.
6
Click
Finish
. The CPE is now configured with the parameters from the ConfigFile.
Figure 3-6: Installing Window
Figure 3-7: Installation Succeeded
Page 44 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 3 - Commissioning
Configuring the Unit Using the WiMAX Modem Application CD
29
Figure 3-8: Installation Complete
Page 45 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 3 - Commissioning
Configuring the CPE Using the IPKG Upgrade
30
3.4
Configuring the CPE Using the IPKG Upgrade
This section explains how to use the IPKG (ITSY Package Management System), provided by the
operator, to automatically configure a CPE and sometimes upgrade its features. Subscribers should use
this procedure upon specific instruction from the operator.
1
From the main menu at the left pane select
Status
and open the
Software
page (
Figure 3-9
).
2
Click
Browse
to upload the *ipk
file provided for this unit.
3
Click
Upgrade
to apply all the parameters in the IPKG file to this unit.
To upgrade the unit using the IPKG:
Figure 3-9: Status - Software Page
19216811.live