Page 71 / 138
Scroll up to view Page 66 - 70
Chapter 6 - Setting Advanced
Parameters
In this chapter:
“Introduction” on page 50
“Authentication” on page 51
“Security” on page 53
“Firewall” on page 55
“MAC Filter” on page 57
“IP Filter” on page 58
“Port Forwarding/Trigger” on page 59
“Dynamic DNS” on page 62
zzAlvarion_ page
Page 72 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 6 - Setting Advanced Parameters
Introduction
50
6.1
Introduction
This chapter describes how to configure advanced parameters, such as: Firewall protection,
authentication methods, security parameters, filters for blocking the access of unauthorized clients, port
forwarding and triggering, and also the Dynamic DNS (Domain Name System) provider.
Page 73 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 6 - Setting Advanced Parameters
Authentication
51
6.2
Authentication
The Authentication page allows you to set the parameters for the authentication method in order to
gain access to the WiMAX network.
The Authentication page includes the following parameters:
Authentication Method
- Select one of the following WiMAX security methods:
»
None - Authentication is disabled
»
EAP-TTLS-MSCHAPV2 (Default) - EAP-Tunneled Transport Layer Security, supporting the Microsoft
version of the Challenge-handshake authentication protocol, version 2.
»
EAP TLS - EAP-Transport Layer Security (available only if enabled by the operator)
When Authentication is enabled, set the following parameters:
NOTE!
Do not change parameters in this page unless specifically instructed by your service provider.
Figure 6-1: Advanced - Authentication
Page 74 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 6 - Setting Advanced Parameters
Authentication
52
User Name
- Enter the user name supplied by the service provider (Default:
CPE MAC
Password
- Enter the user password (supplied by the service provider). Default: quickynikynyoky
Password Confirmation
- Re-enter the user password to confirm it.
Page 75 / 138
BreezeMAX PRO 6000 Product Manual
Chapter 6 - Setting Advanced Parameters
Security
53
6.3
Security
The Security page enables to configure the firewall feature. The firewall feature can be used to block
unauthorized access while allowing only authorized communications from the Internet network. This
feature also allows the device to be managed over the Internet by authorized personnel.
The Security page includes the following parameters:
Enable Web login from Internet
- Select this check-box to access the device from other networks.
When web login is enabled and a port is defined, you can access the device from another network
Simply by opening a browser and entering the address of the device (Default: Enabled
Web Login Port from Internet
- Define a specific port number for security access control (the
default port number is 8080). Available only if Web Login from Internet is enabled.
Enable ping from Internet
- Enables to set the unit to respond to ping commands for
troubleshooting purposes (Default: Disabled).
NOTE!
Do not change parameters in this page unless specifically instructed by your service provider.
Figure 6-2: Advanced - Security
19216811.live