Page 51 / 89
Scroll up to view Page 46 - 50
47
Chapter 5
Advanced Setup
To configure Dynamic DNS:
1.
Click
Dynamic DNS
from the menu on the left side of any Advanced
Configuration screen. The Dynamic DNS screen appears.
2.
Select the Gateway’s Dynamic DNS account provider from the drop-down list.
3.
Enter the Dynamic DNS username and password in the appropriate text boxes.
4.
Enter the full Dynamic DNS domain in Dynamic DNS provider text box, or
select one from the drop-down list.
5.
Click
Apply
.
Page 52 / 89
48
VDSL2/GigE Wireless 11n Gateway
DNS Host Mapping
DNS Host Mapping creates a static host name for the specified IP address. WAN
and LAN addresses are supported. To set up DNS host mapping:
1.
Click
DNS Host Mapping
from the menu on the left side of any Advanced
Setup screen. The DNS Host Mapping screen appears.
2.
Enter the DNS host name in the appropriate text box.
3.
Enter the IP address in the appropriate text box.
4.
Click
Apply
to save changes.
Page 53 / 89
49
Chapter 5
Advanced Setup
Port Bridging
Click
Port Bridging
from any Advanced Configuration screen to generate the
Port1 Bridge screen. This screen allows you to enable port bridging. Click in the
Enable radio button to activate, then click
Apply
.
HPNA Settings
Click
HPNA Settings
from any Advanced Configuration screen to generate the
HPNA Settings screen. This screen allows you to enable HPNA (Home Phoneline
Networking Alliance) networking. Click in the Enable radio button to activate,
then click
Apply
.
Page 54 / 89
50
VDSL2/GigE Wireless 11n Gateway
Admin Password
To change the password that allow access to the Gateway’s firmware screens:
1.
Click
Admin Password
from the menu on the left side of any Advanced Setup
screen. The Admin Password screen appears.
2.
Enter the old password in the Old Password text box.
3.
Enter a new password in the Admin Password text box.
4.
Reenter the new password in the Confirm Your Password text box.
5.
Click
Apply
to save your changes.
Page 55 / 89
51
Chapter 5
Advanced Setup
Storage Service
Click
Storage Service
to access the Storage Service screen. This screen lists the
storage devices connected to the Gateway, and displays information (type of file
system, total and used space) about the devices.
Rebooting the Gateway
To reboot the Gateway:
1.
Click
Reboot
from the menu on the left side of any Advanced Setup screen.
The Reboot Modem screen appears.
2.
Click
Reboot
to reboot the Gateway. This may take up to one minute.
To reenter the Gateway’s firmware after restarting the Gateway, click the web
browser’s Refresh button.
19216811.live