Actiontec M1000 Qwest Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of Actiontec M1000 Qwest router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 8
© 2008 Qwest Communications International Inc.
How to Troubleshoot Wireless Access (Wi-Fi) on the Qwest® Standard Modem: Actiontec®
M1000 with the Qwest® Wireless Module: Actiontec® W1000
Internet Service Provider (ISP):
All
Use this document if:
You want to change one or more of the following settings to troubleshoot your Qwest Standard
Modem: Actiontec M1000 for wireless issues:
1.
Reset your modem to factory defaults (Step 4)
2.
Reprogram your modem (Step 9)
3.
Change your SSID or Network Name (Step 16)
4.
Security key (Step 16)
5.
Channel and power settings (Step 20)
This document assumes:
That you have your PPP username and password that was provided by your Internet
Service Provider (ISP).
Click here
to look up your ISP’s contact information.
Your computer is directly connected to the modem using an Ethernet cable.
The Qwest Standard Modem: Actiontec M1000 is powered on.
Page 2 / 8
© 2008 Qwest Communications International Inc.
1.
First, make sure you have fully installed the Qwest Wireless Module: Actiontec W1000 into
the Qwest Standard Modem: Actiontec M1000. If not, click
here
for installation instructions.
2.
Open a web browser, type
192.168.0.1
, and press enter.
3.
If you have the solid blue screen on the left as shown below, proceed to step 4.
If you have
the blue and white screen to the right, click
here
to see those directions.
4.
These are the steps for resetting your modem to factory defaults.
Select
Utilities
.
Page 3 / 8
© 2008 Qwest Communications International Inc.
5. Select
Restore Default Settings
.
6. Select
Restore Default Settings
again.
7. Select
OK
.
Page 4 / 8
© 2008 Qwest Communications International Inc.
8. Click
Here
.
9.
These are the steps for reprogramming your modem.
Select
Advanced Setup
.
10. Select
WAN IP Address
.
Page 5 / 8
© 2008 Qwest Communications International Inc.
11. Select
PPPoE
.
12. Place a checkmark next to
PPP Auto Connect
if it is not populated
13. Enter the PPP username and password that was provided to you by your Internet Service
Provider (ISP).
Click here
to look up your ISP’s contact information
.
14. Complete the next steps according to your ISP
’s
instructions, then select
Apply.
Listed
below are the most common settings.
15.
You will see the ‘
Thank
You’ screen for a moment.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top